TUHOME Furniture PERU CLW 3922 User manual

PERU 4 DRAWER CHEST
Cómoda Perú
Alto: 88,6 cm
Ancho: 91 cm
Fondo: 45,8 cm
Height: 34,9 in
Width: 35,8 in
Depth: 18,03 in
ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE ENSAMBLE
REF./SKU. CLW 3922
LOT N°
FURNITURE
IF ANY PARTS ARE BROKEN OR MISSING
PLEASE CONTACT US FIRST AT
1-888-391-01-66, OUR CUSTOMER SERVICE
TEAM WILL PROVIDE YOU HELP TO RESOLVE
ANY ISSUES INMEDIATLY

!
WARNING
!
Page 2
IMPORTANT
RECOMMENDATIONS RECOMENDACIONES IMPORTANTES
No pintar el mueble.
El mueble debe ser usado únicamente en interiores,
no exponer al sol directo.
Limpiar los herrajes metálicos con un paño seco.
NO sobrecargar el mueble (ver las cargas sugeridas).
No golpear ni martillar el mueble (solo cuando se
indique).
Limpiar con un paño ligeramente húmedo,
usar jabones suaves.
No arrastre el mueble, levántelo entre dos personas.
Evite el contacto directo con el agua, el fuego o la
exposición a fuentes de calor.
Do not paint the cabinet.
The cabinet MUST be used exclusively indoors,
do not expose to direct sun.
Clean metallic hardware with a dry cloth.
Do NOT overload the cabinet (see suggested loads).
Do not hit or hammer the cabinet (just when
indicated).
Clean with a slightly damp cloth, use gentle soaps.
Do not drag, lift and move between two people.
Avoid direct contact with water, fire or exposure
to heat sources.
Never allow children to climb or manipulate
the cabinet, furniture tip over can cause
serious injuries or death.
ADVERTENCIA
!
Nunca permita que los niños escalen o
manipulen el mueble, la caída de este
puede provocar lesiones graves o la muerte.
FURNITURE

REQUIRED TOOLS* HERRAMIENTAS NECESARIAS*
Page 3
*Not included, and not shown actual size. *No incluidas y no se muestran en tamaño real.
INDEX ÍNDICE
Assembly Hardware 4
Assembly Parts 5
Suggested Loads 6
Assembly Recommendations 6
Assembly Steps 7-17
Warranty 18
Herrajes para Armado 4
Piezas de Armado 5
Cargas Sugeridas 6
Recomendaciones de Ensamble 6
Pasos de Armado 7-17
Garantía 18

x2
Corner Brace
Cantonera
x24
Minifix Cams
Minifix
Spreading Bolt
Perno Minifix
x24 x19
Wood Dowel
Tarugo
x1
Glue
Pegante
Cover Caps
Tapa Adhesiva
Minifix
Flat Head Screw
Tornillo Lámina
x24 x50
x2
Closet Rod Bracket
Soporte Tubo Ovalado
x8
Nail-on Glide
Deslizador Puntilla
x16
Drywall Screw
Tornillo de Ensamble
Closet Rod
Tubo Ovalado
x1 x36
Nail
Puntilla
x5
Handle
Manija Acero
x10
Handle Screw
Tornillo Manija
x4
Drawer Slides
Rieles
Full Overlay Hinge
Bisagra Parche
x2
Drywall Screw +
Wall Anchor
Chazo Mariposa
+ Tornillo Ensamble
x2
ASSEMBLY HARDWARE HERRAJES PARA ARMADO
Page 4
Please check that the hardware content is correct.
If any item is missing, please call to our customer
service line.
Hardware items are NOT shown actual size. Los herrajes no se muestran en el tamaño real.
Compruebe que el contenido de los herrajes sea
el correcto. En caso de que falte alguna pieza, por
favor llame a nuestra línea de atención al cliente.

ASSEMBLY PARTS PIEZAS DE ARMADO
F
A
B
C
D
E
F
G
K
H
IJ
L
MN
O
H
H
H
I
I
I
J
J
J
K
K
K
M
M
M
O
A - x1
B - x1
C - x1
D - x1
E - x1
F - x2
G - x1
H - x4
I - x4
J - x4
K - x4
L - x1
M - x4
N - x1
O - x2
Page 5

MAX SUGGESTED LOADS CARGAS MÁXIMAS SUGERIDAS
ASSEMBLY
RECOMMENDATIONS RECOMENDACIONES DE ENSAMBLE
44lb
22lb
22lb
18lb
18lb
18lb
18lb
18lb
Page 6
20kg
10kg
10kg
8kg
8kg
8kg
8kg
8kg
Two people are recommended to assemble
the product.
Assemble the cabinet on a flat, smooth
surface, preferably on a carpeted floor
or the carton box of the product.
Carefully read the assembly instructions
and identify every wood and hardware
part before start assemblying the cabinet.
Ensamble el mueble entre dos personas.
Ensamble el mueble sobre una superficie
plana y lisa, preferiblemente sobre un
tapete o el cartón de la caja
Lea cuidadosamente las instrucciones e
identifique todas las piezas y herrajes
antes de empezar a armar el mueble.

1
Page 7
2
A
B
x2
Arrow
x4
1
2
!
Do NOT tighten the
cams in this step.
NO apriete las cajas
minifix en este paso.
x6

Page 8
3
4
D
C
!
Do NOT tighten the
cams in these steps.
NO apriete las cajas
minifix en estos pasos.
x2
x4
x1
x2

Page 9
5
6
E
E
x1
x4
!
Do NOT tighten the
cams in this step.
NO apriete las cajas
minifix en este paso.
Arrow
Turn Over
Voltear

Page 10
7
8
Fx2
G
x2
1
2
!
Do NOT tighten the
cams in these steps.
NO apriete las cajas
minifix en estos pasos.
x4

Page 11
9
10
Kx4
Hx4
Ix4
x2
!
Do NOT tighten the
cams in this step.
NO apriete las cajas
minifix en este paso.

Page 12
11
12
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
1
Gently hit the pieces
with a rubber hammer
to adjust the joint.
Golpee suavemente la
pieza con un martillo
de goma para ajustar
el ensamble.
2
x3
G
B
E
G
B
E
F
F

Page 13
13
14
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
1
2
Gently hit the pieces
with a rubber hammer
to adjust the joint.
Golpee suavemente la
pieza con un martillo
de goma para ajustar
el ensamble.
x6
D
C
F
F
G
E
B
A
G
C
B
F
F
E
D

Page 14
15
16
!
Be careful turning over the cabinet.
Tenga cuidado al voltear el mueble.
x2
x4
H
I
J
A
C
N
O
O
1
2

Page 15
17
18
Rotate to tigten.
Gire para apretar.
Gently hit to adjust.
Golpee suavemente
para ajustar.
Slide.
Deslice.
x2
x4
x4
M
I
H
J
K
M
J
H
I

19
Page 16
x2
Side adjustment
Ajuste lateral
Height adjustment
Ajuste de altura
Depht adjustment
Ajuste de profundidad
Door Installation
Instalación de las Puertas
Closet Rod
Tubo ovalado
Hinge adjustment
Ajuste de las bisagras
A
O
C
F
FL
E
D
G

20
Page 17
!
For the user safety, it is recommended
to anchor the furniture to the wall.
1 2
Slide the drawers
inside the cabinet.
Deslice los cajones
dentro del mueble.
A
C
L
K
K
K
K
After you finish the adjustment
of the cams, cover them with
the cover caps.
Después de ajustar todas las
cajas minifix, cúbralas con las
tapas adhesivas.
After you finish assembling the
cabinet, take off the adhesive
letters.
Al terminar de armar, desprenda
las letras adhesivas.
A
Por la seguridad del usuario se recomienda
anclar el mueble a la pared.

Page 18
WARRANTY POLICY
PÓLIZA DE GARANTÍA
TUHOME Furniture has a 3 year warranty coverage in wooden parts and 1 year warranty
coverage in hardware pieces since its manufacturing date, which you can see in the lot
number printed on the product box and the assembly instructions leaflet.
Warranty covers materials and workmanship imperfections which impair the assembly
or correct functioning of the cabinet.
This warranty is not valid if the defects or imperfections are caused by the incorrect
following of the assembly instructions, warnings and recommendations, misuse,
intentional damage, fire or flood, or after modifications or any kind of alteration, or
repaired by someone not authorized by TUHOME Furniture, when it´s been assembled 3
months after the date of purchase. These defects MUST be reported before the warranty
coverage period ends. Once the product has been assembled, the company will not be
responsible for defective and/or damaged parts.
This warranty is ONLY valid for the ORIGINAL PURCHASER, it doesn’t apply if the
product has been resold, rented, etc.
TUHOME Furniture will take no liability for incidental or consequential damages caused
to or by the product (This may not apply in your state).
To make this warranty valid you must write to our customer service email describing the
product defect, lot number and submitting your sales reciept or proof of purchase, or
contact us at our customer service line. Replaced parts will be under the product´s
original warranty coverage period. Damaged parts will become property of the
company.
There are no other warranties applicable to this product.
IF ANY PARTS ARE BROKEN OR MISSING
PLEASE CONTACT US FIRST AT
1-888-391-01-66, OUR CUSTOMER SERVICE
TEAM WILL PROVIDE YOU HELP TO RESOLVE
ANY ISSUES INMEDIATLY
FURNITURE