USB charging cable connection
adapter to charge the power controller
for 3-4 hours (5V/2A). The USB
interface can charge other electronic
devices. Note: Please charge it with a
5V/2A Charger!
Step 1:
Turn middle gray part to left, remove
needle,replace the required bits,and
turn right to lock bit tightly. Note:
When you replace bit,please DON'T
close drill hole Without insert bit.
Step 2:
Use DC cable to connect power
controller and nail drill.
The carriage is inserted into the side of
the power controller and can be
replaced on both sides.
Step 3:
Press ON/OFF button, turn the circular
knob to adjust speed, toggle the
two-way button to switch the F/R
direction of rotation.
Step 4:
Ready to work. Note: After use, please
insert the attached needle.
Note: The nail drill machine DOES NOT
come with Charger, but is USB charging.
And please.
Step 5:
