TURBO RACING TX User manual

www.turboracinghobby.com

www.turboracinghobby.com
Thank you for choosing our company's products! If this is your first time using this remote controller, please read this
manual carefully before using it and operate it follow the instructions strictly. You can also check the manual if you
encounter problems during the operation. Please keep the manual after use for future use. Thank you again for using
our products and hope to bring you a new and interesting world.
If you find any problems in using our products, please check the instructions for the first time. Or if you need our relevant
information, you can contact us through our website: www.turboracinghobby.com
Introduction
Services
Copyright NewStone Technology co.,ltd
14+ This product is not suitable
for children under 14 years.
MADE IN CHINA
This safety warning must be strictly implemented. As company policy shall not be liable for any loss caused by failure to comply
with the safety warning. Should you ignore the operating and safety instructions, the warranty will be void.
This product is not a toy, its operation must be learned step by step. And only suitable for people who over 14 years. Please do not
let children operate the model, and be careful when have children on site when operating models.

www.turboracinghobby.com
4x AA Battery
RECEIVER SPECIFICATIONS
RX41
Receiver
4.8 - 10.0V
4CH
RADIO SPECIFICATIONS
P62
AA x4
179.00
4CH
219.30
114.80
Battery Installation

www.turboracinghobby.com
BING
Signal
Positive Pole
Negative Pole
Antenna
Steering Wheel
Hand Grip
Battery compartment
Power switch
Throttle Trigger
LCD Display
CH3
CH4
TH Trim+
TH Trim-
ST Trim+
ST Trim-
SEL
CH -
+
2. Receiver Functions
1. Radio Functions
Functions
Channel 1
Channel 2
Channel 3
Channel 4

LED
CAUTION: NEVER CONNECT A BATTERY WITH VOLTAGE
HIGHER THAN 10.0V TO THE RECEIVER, DOING SO COULD
DAMAGE THE ELECTRONICS.
Connection(RX41)
•Channel 1: Controlled by the wheel, connect to a servo
for steering.
•Channel 2: Controlled by the trigger, connect to the
ESC or a servo for throttle/brake.
•Channel 3: Controlled by the adjustment knob
(0-100%) for optional use. This port can also be used
to connect a transponder device used in racing.
•AUX (Channel 4): Controlled by button (ON/OFF) for
optional use. This port is most commonly used for LED
light kits. Use this port to connect an external battery
for use with gas powered vehicles.
Electric powered model
ESC
Steering Servo
Receiver
Pairing The Transmitter & Receiver(RX41)
Note: Radio systems installer in RTRs have already been bound. Only when installing a new transmitter or receiver is the
above process necessary
1. Turn on the receiver power. Press the SW switch.The receiver’s LED should start flashing.
2. Turn on the transmitter.
3. When the LED on the receiver becomes solid,the binding process is completed.
Operation

SVC:
D/R: D/R-ST D/R-TH

www.turboracinghobby.com
Using Caution While Operating
Fail safe function setting
General Care
1. Always use clean, dry cloth or soft bristle brush to clean your equipment.
2. Never use chemical cleansers, as these could damage the sensitive electronics and plastics.
Please turn on the TX, then pull the TH trigger anywhere you want to and hold it, press the SW button
of the receiver about 2sec,the LED should start flashing for 5sec,then release SW button and
TH trigger, turn off the TX.