TW Audio MKC5 User manual

Assembly ManualMKC5

24
Introduction
Thank you for choosing a high quality product „MADE IN GERMANY“ from TW AUDiO.
MKC5 is an mounting kit for the loudspeaker C5.
The features of this accessory kit are its uncomplicated quick handing, its unobstrusive look and its
ratio in size and weight.
If you lend your product to another party, inform that party of the safety-related handling procedures
and hand over this assembly manual. Additional copies of the manual can be obtained through
TW AUDiO free of charge or downloaded directly from our website: www.twaudio.com
Contents
1. Safety | Intended use........................................................ 27
2. Purchased parts package................................................. 29
3. Wall plate.......................................................................... 30
4. Adapter bracket................................................................ 34
5. Mounting bracket.............................................................. 38
6. Disposal............................................................................ 45
- ENGLISH -

25
Assembly Manual / MKC5
Introduction in the assembly manual
Strictly adhere to the instructions contained in this assembly manual which are marked as follows:
This symbol in combination with the signal word „Caution“ identifies a potentially
hazardous situation. Failure to comply with this safety instruction can lead to light
or moderate injury.
This symbol in combination with the signal word „Note“ identifies a potentially hazar-
dous situation. Failure to comply with this safety instruction can lead to product
damage.
This symbol in combination with the signal word „Tip“ identifies additional infor-
mation or notes that will simplify working with TW AUDiO products on the basis of
practical experience.
This symbol in combination with the signal word „Warning“ identifies a potentially
hazardous situation. Failure to comply with this safety instruction can lead to serious
injury or even death.
NOTE
TIP
CAUTION
WARNING
Notes on the products
Read manual
before use!
Before setting up the device, carefully read the assembly manual and keep this
document in a safe place together with the MKC5 mounting kit.

26
Assembly Manual / MKC5
General information
Assembly manual: AM-MKC5
Version 1.0 en, 01/2016
© by TW AUDiO 2016; all rights reserved.
All information contained in this assembly manual was correct to the best of our knowledge at the time
of printing.
Quality warranties or assurance of suitability for a certain type of use based on the technical specifica-
tions, dimensions and weights are not granted by TW AUDiO.
TW AUDiO also shall not assume liability for any secondary damage (property damage and/or personal
injury) nor for the failure to comply with this assembly manual.
TW AUDiO reserves the right to make changes that take into account the latest engineering
advancements.
TW AUDiO is pleased to receive suggestions for improvement and recommendations on this assembly
manual. Please send us any feedback you may have to the following e-mail address.
[email protected]
TW AUDiO GmbH
Osterholzallee 140-2
71636 Ludwigsburg
Phone: [phone]
Fax: [phone]

27
Assembly Manual / MKC5
1. Safety | Intended use
Please adhere to the following safety instructions to avoid risks when handling the mounting kit.
The MKC5 was developed for professional use in sound systems. The mounting kit may only be used
by trained and qualified personnel.
Note the handling modes described in this assembly manual.
Other uses are not permissible.
TW AUDiO shall not be liable for any damage that ensues from unintended use.
Check that the accessory kit is complete and that all parts are in good condition
before mounting them.
The accessory kit contains specific screws and nuts. Do not use other screws or
nuts as these can damage the threads and threaded inserts.
WARNING
WARNING
The C5 is only to be used with accessory kit MKC5. Description for mounting is in
the assembly manual. Other applications are not permissible.
All parts described in the manual (wall plate, adapter bracket, mounting bracket)
are only to be used as described. Any other use is not permissible and may lead to
injury and damage of the parts.
Any form of modifications of the elements is strictly prohibited. Risk of injury!
The C5 and the mounting kit MKC5 are suitable for indoor and outdoor applications.
CAUTION
WARNING
The MKC5 should be handled by qualified and trained personnel only. Before every
use the MKC5 has to be checked if it is ready for use.
WARNING
Do not use the MKC5 if any form of damage is visible.

28
Assembly Manual / MKC5
Before mounting the MKC5 check that walls, ceilings, tripods are capable of
carrying the payload of the MKC5.
The MKC5 has a payload of 5 kg. Do not exceed this payload.
Make sure that no water pipes, electrical lines or any other lines are behind the
intended place of mounting.
Only use wall plugs and screws which are suitable for the intended place of moun-
ting. All screws must be set and tightened properly. Ensure that your fixing holes
have the correct depth and diameter. Always use all fixing holes.
Once mounted, the C5 has a swivel range. Ensure no object from the mounting set
is within this swivel range. The C5 must be able to be swiveled freely.
WARNING
Do not squeeze or twist the electrical cables of the C5 during installation. The res-
pective national electrotechnical rules and regulations are applicable.
CAUTION
Please keep all mounting elements away from children! The small parts can easily
be swallowed and lead to suffocation!
WARNING
Always use the spring washer for added safety. It will prevent the screws from beco-
ming loose. Spare parts are available from TW AUDiO.
When the C5 is being moved frequently, the couplings may become loose. Please
check the connections regularly and tighten if necessary. If tightening is not pos-
sible, then the mounting elements must be exchanged (screw Nr.1, nut Nr.9, spring
washer Nr.8, ball pin Nr.7).
WARNING

29
Assembly Manual / MKC5
2. Purchased parts package
1. Hexagon head screw M10 x 16.........................................................................................3 pcs
2. Adapter bracket................................................................................................................. 1 pc
3. Wall plate............................................................................................................................1 pc
4. Mounting bracket............................................................................................................... 1 pc
5. Clamp with thumbscrew...................................................................................................... 1 pc
6. Ball mount........................................................................................................................... 1 pc
7. Ball pin................................................................................................................................ 1 pc
8. Spring washer......................................................................................................................1 pc
9. Nut M10...............................................................................................................................1 pc
An anti-twist protection is fixed at the ball pin and the hexagon head screws. This
prevents the ball pin and screws from loosening.
CAUTION
Needed tool:
Combination spanner SW17.

30
Assembly Manual / MKC5
3. Wall plate
Installation dimensions | all dimensions in millimeter
The wall plate can be mounted at ceilings, walls and other suitable surfaces. Please
use the fittings from our mounting kit.
NOTE
220
73
284

31
Assembly Manual / MKC5
225
100
203
m
a
x
.
4
0
°
203
18
18
207
220
m
a
x
.
-
4
0
°

32
Assembly Manual / MKC5
Place the clamp above the ball pin.
Use compatible mounting material.
CAUTION
CAUTION
Tighten ball pin properly!
(18 Nm)
Tighten screw
properly! (18 Nm)
Wall / ceiling

33
Assembly Manual / MKC5
Tighten the thumb screw of the clamp.Pull the clamp over the ball mount.
Plug the ball mount on to the ball pin.

34
Assembly Manual / MKC5
4. Adapter bracket
The adapter bracket can be mounted on ceilings, walls and other suitable surfaces.
Please use the fittings from our mounting kit.
Installation dimensions | all dimensions in millimeter
NOTE
57 57
222 164
57 57
222
57 57
57 57
164

35
Assembly Manual / MKC5
230
m
a
x
.
-
4
0
°
201
163
227

36
Assembly Manual / MKC5
Version 1:
Version 2:
Wall / ceiling
Use compatible mounting material.
Tighten screw properly!
(18Nm)
CAUTION

37
Assembly Manual / MKC5
Place the clamp above
the ball pin.
Tighten the thumb screw of
the clamp.
Plug the ball mount on to
the ball pin.
Pull the clamp over the
ball mount.

38
Assembly Manual / MKC5
5. Mounting bracket
The mounting bracket can be used for mounting on walls, ceilings, tripods as well
as threaded rods. Please use the fittings from our mounting kit.
Installation dimensions | all dimensions in millimeter
NOTE
m
a
x
.
-
2
0
°
246
288
203
300

39
Assembly Manual / MKC5
210
4
0
°
203
222
m
a
x
.
-
2
5
°
186
214
300

40
Assembly Manual / MKC5
m
a
x
.
-
4
0
°
208
300

41
Assembly Manual / MKC5
201
222
m
a
x
.
2
5
°
213
187

42
Assembly Manual / MKC5
CAUTION
CAUTION
Tighten screw / nut properly!
(18Nm)
Tighten screw
properly! (18 Nm)