TWC Zipscreen Installation manual

- Press up button to confirm
blind will travel in the up
direction.
- If blind is travelling in the wrong
direction, hold up & down
buttons at the same time until
motor jogs.
- Check direction of blind to
make sure this is now travelling
in the correct direction.
check blind direction
wirefree
outdoor motor
programming
instructions
- Remove end cap off solar
panel (right hand end).
- Select a channel on
remote.
- Hold programming button
on solar panel for
approximately 5 seconds
until a clicking sound is
heard and LED light will
light up once.
- Hold stop button down on
remote until motor jogs
confirming successful
pairing (LED light will flash
on solar panel 3 times).
initial pairing
- Press the down button on
remote and stop blind before it
reaches the bottom of the
opening.
- Insert the wand supplied into
the white setting hole.
- Turn the wand in an anti-
clockwise direction and the blind
will lower with each rotation.
- Continue to turn the wand until
the desired bottom limit is
reached.
- If the blind needs to be raised
to adjust the bottom limit, rotate
the wand clockwise to adjust.
- Once the bottom limit is
reached press and hold the stop
button to lock this position
(approx. 5 seconds).
setting bottom limit left
hand control side

- Press the down button on the
remote and stop the blind before it
reaches the bottom of the opening.
- Insert the wand supplied into the
red setting hole.
- Turn the wand in a clockwise
direction and the blind will lower
with each rotation.
- Continue to turn the wand until
the desired bottom limit is reached.
- If the blind needs to be raised to
adjust the bottom limit, rotate the
wand anti-clockwise to adjust.
- Once the bottom limit is reached
press and hold the stop button to
lock this position (approx. 5
seconds).
setting bottom limit right
hand control side
- Press the up button on remote and
stop blind before it reaches the top of
the opening.
- Insert the wand supplied into the
white setting hole.
- Turn the wand in a clockwise
direction and the blind will raise with
each rotation.
- Continue to turn the wand until the
desired top limit is reached.
- If the blind needs to be lowered to
adjust the top limit, rotate the wand
anti -clockwise to adjust.
- Once the top limit is reached press
and hold the stop button to lock this
position (approx. 5 seconds).
setting top limit right hand
control side
-Press the up button and stop the
blind before it reaches the top of
the opening.
- Insert the wand supplied into the
red setting hole.
- Turn the wand in a clockwise
direction and the blind will raise
with each rotation.
- Continue to turn the wand until
the desired top limit is reached.
- If the blind needs to be lowered to
adjust the top limit, rotate the wand
anti-clockwise to adjust.
- Once the top limit is reached
press and hold the stop button to
lock this position (approx. 5
seconds).
setting top limit left hand
control side
If a factory reset is required,
remove end cap, hold
programming button down on
solar panel until 4 clicks are
heard and LED light flashes 4
times (approx. 14 seconds).
factory reset
(if required)
Once limits are set, install end
cap back on to solar panel (right
hand end).
finish