TZUMI ProBuds Q Series User manual

2
Charging Button
The two earbuds have been connected to each other by factory, you
don't need to pair them again.
1. Choose left or right earbud to be your MASTER earbud .Follow the
steps of SINGLE EARBUD PAIRING to connect it with your phone .
2. Turn on the other earbud ,wait for a few seconds ,two earbuds will
be connected each other automatically .The blue light will flash
once every 7 seconds .Both earbuds are now ready for use.
3. If you want to change MASTER earbud , please follow above
steps again.
4. After successful pairing, devices will remember each other.
Therefore, no pairing will be needed next time. Both earbuds will
be automatically connected and paired to Bluetooth device.
If two earbuds connection fails,please turn off two earbuds and
follow below steps .
1. Choose left or right earbud to be your MASTER earbud .Follow the
steps of SINGLE EARBUD PAIRING to connect it with your phone .
2. Turn on the other earbud . Quickly press both earbuds on
multi-function 3 times to enter earbuds pairing mode . Wait for two
earbuds connecting for a few seconds . The blue light will flash once
every 7 seconds if connected .Both earbuds are now ready for use.
Make sure the Bluetooth function is available on your electronic devide.
Specific pairing procedures may vary slightly depending on the devide.
For detailed information, please refer to your device’s User Guide.
·Keep the distance between the device and the tzumi earbuds
within 3 feet (for pairing only).
·If no device connection is made within 10 minutes of the earbuds
being switched on, the earbuds will automatically switch off to
save power.
1. Place earbuds into charging station.(Please tear the stickers on
earbuds first)
2. White lights around earbuds turn on when charging has begun.
White light turns off when charging is complete.
These earbuds have an internal rechargeable battery. The battery
must be fully charged prior to use. Charging time is approximately
2 hours. Earbuds cannot be used white charging.
If pairing does not work, power off the earbuds and follow pairing
steps again.
Make sure the earbuds is fully charged before using it for the first
time. The earbuds will not turn on if battery level is very low.
Check the Bluetooth connection between the earbuds and your
device. If connection is not established, please reconnect again
and adjust volume level as needed.
1. When earbuds are power off, press and hold the muli-function
button for 4 seconds until blue and white lights flash quickly. Soon
you may hear prompt “ pairing.”
2. Activate the Bluetooth function on your device to search for
Bluetooth devices. Look for “Tzumi-TWE-L” in device list displayed
and select.
3. When successful connection is made , blue light will flash once every
7 seconds. Left earbud is now ready for use.
1. When earbuds are power off, press and hold the muli-function
button for 4 seconds until blue and white lights flash quickly. Soon
you may hear prompt “ pairing.”
2. Activate the Bluetooth function on your device to search for
Bluetooth devices. Look for “Tzumi-TWE-R” in device list displayed
and select.
3. When successful connection is made , blue light will flash once every
7 seconds. Right earbud is now ready for use.
Press round button on charging station to activate charging, place
earbuds into charging case. Earbuds will turn off.
If BOTH earbuds are being used togerther, press and hold multi-function
button on MASTER Earbud only for 4 seconds until you hear “power off ”
or see the white light appear for 1 second. MASTER Earbud will turn OFF
and Right earbud will turn OFF automatically.
If only SINGLE earbud is used, press and hold multi-function button
on that earbud for 4 seconds, SINGLE earbud will ture OFF.