U-Line H-5816 User manual

PAGE 1 OF 3 0816 IH-5816
πH-5816
PIPE CLOTHING
RACK – SINGLE RAIL
1-800-295-5510
uline.com
PARTS
TOOLS INCLUDED
Allen Wrench Wrench
Caster x 4 Adjustable Connector x 2 Set Screw x 2
Bottom Upright x 2
Base x 1
Top Upright x 2
Hangbar x 1

PAGE 2 OF 3 0816 IH-5816
ASSEMBLY
1. Screw the four casters into the base using provided
wrench. (See Figure 1)
2. Thread each bottom upright into the base.
(See Figure 2) To fully secure uprights, place
included wrench into pipe slots and tighten fully.
(See Figure 2a)
NOTE: Ends with slots should be facing up.
3. Screw an adjustable connector to the top of each
bottom upright. Make sure connectors are facing
out. (See Figure 3)
4. Tighten set screws using Allen wrench to lock
adjustable connectors in place. (See Figure 4)
Figure 1
Figure 2a
Figure 2
Figure 3
Figure 4
Facing
Out
Facing
Out
Set
Screw

PAGE 3 OF 3 0816 IH-5816
ASSEMBLY INCLUDED
5. Twist each top upright into hangbar. (See Figure 5)
NOTE: Ends with slots should be facing down.
6. Loosen adjustable connectors and insert hangbar
with top uprights from step 5. Drop to desired height
and lock into position by retightening connectors.
(See Figure 6)
Figure 5
Figure 6
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com