
INSTRUCTIONS
for using your Save-A-Tow Tra tion Ramp™ in snow,
i e (not glare i e), sand or mud.
Use the Ramp the se ond your wheels start to spin. The
shallower the hole, the qui ker you’ll be out.
1. Stuck dead center. 2. Roll forward and
set brake.
3. Shove Ramp in place
firmly like a shoehorn. 4. SLOWLY back out.
REVERSE THIS PROCEDURE IF YOU WISH TO DRIVE FORWARD
CAUTIONS:
NEVER spin your wheels on the Ramp. You will melt the
studs with 600ofriction. Move out slowly.
NEVER use the Ramp on flat, lare ice. It won’t help
and you may break the Ramp. Instead, use sand, ashes,
newspaper, etc.
WARNING: NEVER allow anyone to stand or kneel
behind or in front of your vehicle. You could seriously
injure anyone in the way.
GUARANTEE
We uarantee that the Save-A-Tow Traction Ramp™ will
support more than a 2,000 pound load - one wheel of an
unloaded car, van, SUV or pick-up truck. If it does not,
contact us at: www.ussafetysolutions.com. After testin ,
if found defective, it will be replaced at our expense.