U-Turn Orbit User manual

Wrap the belt around the pulley groove. Then hold the
belt along the platter’s back edge with your right hand.
Keeping your right hand in place, use your left hand to
guide the belt around the edge of the platter.
To change speeds, move the belt to the top pulley
groove (33 RPM) or bottom groove (45 RPM).
The belt should be relatively loose – this helps prevent motor
vibrations from reaching the stylus and minimizes platter speed
variation. Avoid pulling on the belt or pulley during installation.
2Belt installation and changing speeds
3Removing the stylus guard
Orbit Turntable
Setup Guide
1Initial setup
Place the platter on the center spindle.
Slide the dust cover onto the hinges.
Connect the power adapter to the jack on the back of your Orbit.
Connect to your sound system using the included RCA cables.
For Audio-Technica, Grado,
and Ortofon OM5E:
Pull cover forward until it slides off.
For Ortofon 2M
Red and Blue:
Pinch tab then pull
cover down.
A
A
A
A
B
B
B
B
C
C
C
C
D
D

You can also connect your Orbit directly to any receiver or
amplifier that has a clearly marked “phono” input on the back.
on o
Using an external phono preamp
3-year warrantyAdditional support
If your Orbit doesn’t have a built-in preamp, you can connect
it to a standalone phono preamp then connect to powered
speakers or an amplifier.
Setup videos & tutorials
uturnaudio.com/orbit-setup
Email
[e-mail]
Phone
[phone]
We stand by our turntables with a 3-year
warranty that covers any defects in
materials or workmanship.
You can view our full warranty policy at
uturnaudio.com/warranty.
If you need warranty service, please
contact us at [e-mail] or
by phone at [phone].
on o
on o
Using the built-in phono preamp
The built-in preamp is set to “on” out of the box. To disable it,
press the bypass switch. The preamp is enabled when the LED
light is on.
RCA jacks preamp bypass switch
turntable
turntable turntable
© 2019 U-Turn Audio, Inc.
built-in preamp
powered speakers or amplifier
powered speakers or amplifier
receiver or integrated amp
phono input
phono preamp
preamp LED
With the built-in preamp enabled, you can connect your Orbit
directly to powered speakers or an amplifier using the included
RCA cables.