Ubiquiti RocketDish RD-5G31-AC User manual

airMAX®Carrier Class
2x2 PtP Bridge Dish Antenna
Model: RD-5G31-AC

Introduction
Thank you for purchasing the Ubiquiti Networks™RocketDish™,
an airMAX® Carrier Class 2x2 PtP Bridge Dish Antenna.
This Quick Start Guide is designed to guide you through
the installation of the antenna. This Quick Start Guide also
includes the warranty terms and is for use with the RocketDish,
modelRD-5G31-AC.
Package Contents
Dish Antenna with Radome Mounting Bracket
Protective
Shroud
Pole Clamps
(Qty. 2)
Stabilizer Brackets
(Qty. 2)
RF Cables
(Qty. 2)
Elevation Rod M10x170 Carriage Bolts
(Qty. 4)
airMAX®CarrierClass
2x2PtP Bridge Dish Antenna
Model:RD-5G31-AC
M10x100 Bolts
(Qty. 2)
M10x25 Carriage Bolts
(Qty. 3)
Quick Start Guide
Products may be different from pictures and are subject to change without notice.
TERMS OF USE: Ubiquiti radio devices must be professionally installed. Shielded Ethernet
cable and earth grounding must be used as conditions of product warranty. TOUGHCable™is
designed for outdoor installations. It is the customer’s responsibility to follow local country
regulations, including operation within legal frequency channels, output power, and Dynamic
Frequency Selection (DFS) requirements.

Installation Requirements
• Rocket™M5 AC PTP, RocketM5 Titanium, RocketM5, or
RocketM5GPS (soldseparately)
• 16 mm or 5/8" wrench
• 24 mm or 15/16" wrench
• Shielded Category 5 (or above) cabling should be used for
all wired Ethernet connections and should be grounded
through the AC ground of the PoE.
We recommend that you protect your networks from the
most brutal environments and devastating ESD attacks
with industrial-grade shielded Ethernet cable from Ubiquiti
Networks. For more details, visit www.ubnt.com/toughcable
Hardware Overview
H
V
Fully Assembled Back View
Elevation Rod
Mounting Bracket
Pole Clamp
Pole Clamp
Protective Shroud
Stabilizer Brackets

Hardware Installation
Important: Carefully handle the Dish Antenna with
Radome. Deformations in its shape may reduce the
effectiveness of the RocketDish.
1. Attach the RF Cables to the connectors labeled Chain 0 and
Chain 1 on the RocketM.

2. Attach the RocketM to the Dish Antenna with Radome.
a. Align the mounting tabs on the back of the RocketM
with the Rocket mounting bracket.
b. Slide the RocketM down to lock it into place.
H
V