Ubiquiti UVC-G3-DOME User manual

Camera MountingBracket CeilingBackingPlate
FlatHeadScrews(Qty.4) KepsNuts(Qty.4) Screws(Qty.4)
ScrewAnchors(Qty.4)
PackageContents
InstallationRequirements
Phillipsscrewdriver
Drillanddrillbit(6mmforwallmountingor3mmforceilingmounting)
Cat5/6cableforindoorinstallations
OutdoorInstallationRequirements
Important:TheUVCG3Domemaybeinstalledoutdoorsunderaneaveor
UVCG3DOMEQuickStartGuide

otherprotectedlocation.DonotinstalltheUVCG3Domeinanopen
environment.
Mountinglocationshouldbeatleast60cm(2ft)fromtheedgeoftheeaveor
ceiling.
Cablefeedmustbepointeddownwardswhenwallmounted.
ShieldedCategory5(orabove)cablingwithdrainwireshouldbeusedforall
outdoorwiredEthernetconnectionsandshouldbegroundedthroughtheAC
groundofthePoE.
Werecommendthatyouprotectyournetworksfromharmfuloutdoor
environmentsanddestructiveESDeventswithindustrialgrade,shielded
EthernetcablefromUbiquiti.Formoredetails,visitui.com/toughcable
Surgeprotectionshouldbeusedforalloutdoorinstallations.Werecommend
thatyouusetwoEthernetSurgeProtectors,modelETHSPG2,onenearthe
UVCG3Domeandtheotherattheentrypointtothebuilding.TheETHSPG2
willabsorbpowersurgesandsafelydischargethemintotheground.
HardwareOverview

CableGland
SecuritySlot
LED
EthernetPort
ResetButton
microSDSlot
Foroutdoorinstallations,ensuretherubberCableGlandisinstalledforadded
protection.
WhenremovingtheG3DomeCamerafromtheMountingBracket,inserta
paperclipintheSecuritySlottoreleasetheLockTabandturntheG3Camera
counterclockwise.
TheLEDwilllightsteadyblueduringbootup.Afterbootup,theLEDwillflash
untilthecameraisadoptedbytheNVR.UponadoptiontheLEDwilllight
steadybluefor10minutesandthenturnoff.
TheEthernetportisa10/100Ethernetportusedtoconnectthepowerand
shouldbeconnectedtotheLANandDHCPserver.
Toresetthecameratofactorydefaults,pressandholdtheResetbuttonfor
morethan10secondswhilethecameraispoweredon.

Reservedforfutureuse.
HardwareInstallation
WallMount
1.
2.

Optional

3.
4.

5.
6.
7.

8.
Optional
9.

10.
CeilingMount
1.

2.
3.