UIC BEZEL8-S User manual

B8-S manual
Page 1
UIC BEZEL8-S
BEZEL8-S Credit card Reader
Specification:
Specification
Processor Microchip SAMA5D23
Memory DDR3 256MB
Storage QSPI-Flash 32MB
Display Graphic LCD @ 128 x 64
OS Linux
Audio Buzzer≧70dB @ 10cm
Reader
Magnetic Card Reader
Bi-directional, support triple tracks
ISO7811
Speed 5 to 40 IPS
1,000,000. swipe times
Smart Card Reader
ISO7816, T=0 , T=1
EMV Level 1, Support 5V/3V
500,000. inserted times
Contactless Support ISO 14443 Type A/B and Mifare with 4 LEDs, EMV contactless L1
I/O
RS-232/USB USB(VCOM) or RS232, Cable-select
AUX RS232, as auxiliary port
LAN 10BASE-T/100BASE-T ethernet
DC in 5V, 500mA
SAM x 1
Debug console Special cable through auxiliary port
LED indicator x 4 for RFID, 1 set for MSR, 1 set for ICC
Buttons Rubber button x 2
Communication
Ethernet x 1 (Optional)
Environment
Operating Temperature -20°C to +70°C
Storage Temperature -30°C to +80°C
Humidity 5% to 90%
Reliability Requirements
MTBF 50,000 hours
ESD Contact：+/- 8KV Air：+/-15KV
Centurion/ Metal card：+/- 8KV(insert half of the card)
Button 1M times

B8-S manual
Page 2
IP Level IP54
IK Level IK06
UV UV exposure resistance
Installation guide(RS232 Interface)
1 Plug the RS232 cable to the port of PC or system
2 The reader will boot up automatically
Photos:

B8-S manual
Page 3
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.