UL PELONIS HC-0128H User manual

OWNER’S MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS
Model HC-0128H
Pedestal Ceramic
Heater
With Remote
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
If provided, use handles when moving this heater. Keep combustible materials, such
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from
the front of the heater and keep them away from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids
and whenever the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner. Return heater to
authorized service facility for examination, electrical or mechanical adjustment, or
repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor
locations. Never locate heater where it may fall into bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, first turn controls to off, then remove plug from outlet.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not
use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where
gasoline, paint, or flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any other use not recommended by
the manufacturer may cause fire, electric shock, or injury to persons.
14. Avoid the use of an extension cord because the extension cord may overheat and
cause a risk of fire. However, if you have to use an extension cord, the cord shall be
No. 14 AWG minimum size and rated not less than 1875 watts.
15. This heater draws 12.5 amps during operation. To prevent overloading a circuit, do
not plug the heater into a circuit that already has other appliances working.
16. It is normal for the plug to feel warm to the touch; however, a loose fit between the AC
outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact
a qualified electrician to replace loose or worn outlet.
17. The output of this heater may vary and its temperature may become intense enough to
burn exposed skin. Use of this heater is not recommended for persons with reduced
sensitivity to heat or an inability to react to avoid burns.
18.“SAVE THESE INSTRUCTIONS”

OPERATING INSTRUCTIONS
Fig.1 Control Panel View Fig.2 Remot e Cont rol Panel
View
Place the heater on a firm level surface free from obstructions, and at least 3 ft. away from
any wall and any other objects such as furniture, curtains, plants or combustible material.
With the Power Switch “A” in the ”OFF” position, plug the heater into a grounded 120V outlet.
Turn the heater ”ON” and “OFF” by pressing the Power Switch “A” .
•To operate heater in heating setting, press HEAT button.
•To use heater in fan only setting, press FAN button. Press once again to cancel fan only
setting.
•To heat a wide area of space it is advisable to use the oscillation feature .To use the heater
in oscillation mode, first make sure the heater is on HEAT or FAN mode .Press once again
to switch the oscillation feature off.
•Temperature setting:
When the heater is on, press “Up” or “Down” key and the Temperature will is switched circularly
in sequence of 65 oF.-70 oF.-75 oF.-80 oF.-85 oF. (75 oFis the ex-factory setting).
Note: Heater will continue working in 10 —30 seconds in order to blow out the hot
air inside the unit. Finally remove the plug from the socket.
Control
Panel
Remote control: This heater has a 6 keys remote with the following function
(See Fig.2) :
1. ON/OFF: Power switch key, used to turn the heater on when plug in or turn off the
heater when the heater is under working.
2. OSC: Oscillation switch, used to enable the oscillation function by pressing once. To
UNPACKING AND SET-UP
Unpack your heater and remove the wheel assemblies from the package.
1. Make sure the heater is unplugged and in the ”OFF” position.
2. TURN THE HEATER UPSIDE DOWN. Un-fasten the four screws.
3. Position the two holes assemblies of the two half bases and fix them as shown.
4. Insert each U-shape screw into the holes of base.
5. Insert the butterfly nuts and screw them tightly.
6. Turn the heater upright.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in
order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH
OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-
season storage.
IMPORTANT!
Your heater is equipped with a
polarized alternating current
line plug (a plug having one
blade wider than the other).
This plug will fit into the power
outlet only one way. This is a
safety feature. If you are
unable to insert the plug fully
into the outlet, try reversing
the plug. If the plug should
still fail to fit, contact your
electrician to replace your
outlet. DO NOT defeat the
safety purpose of the
polarized plug.
Carry Handle
（Behind）
C
B
HEAT
UP
ON&OFF
FAN
DOWM
OSCILLATION
Fig.1 Control Panel Functions
A
C
B
Oscillation Switch
Power Switch
Heat Mode
A

SERVICE & SUPPORT
In the event of a warranty claim or if service is required for this heater, please contact us at
the following:
Toll Free: 866-876-4332
ONE (1) YEAR LIMITED WARRANTY
•Please read all instructions before attempting to use this product.
•Please return the Warranty Registration card within fifteen (15) days from the date of
purchasing this product.