UMS 260 AC User manual

60" (1500mm)
Ceiling Fan
User Manual
Read this manual completely before operating this appliance.
This appliance is not to be handle by any person (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they are surpervised by a professional or have been given instructions.
Children are highly advised not to play with this appliance.
Lot 5, Jalan Ipoh, Batu 17 1/2, Rawang Industrial Estate,
48000 Rawang, Selangor
United MS Electrical Mfg (M) Sdn Bhd
SPECIFICATION
Voltage Fan
Size Frequency Wattage Air Delivery C.O.P Speed (RPM)
240V
AC 60" 50Hz 80W L H
90 260
*Specifications will vary and subject to change without prior notice
Rev 1.4 (8/23)
Ensure this appliance is properly earthed.
Ensure that the ceiling hook can sustain more than 10 times
the Ceiling Fan weight.
Do not replace any part other than UMS brand. This is to
ensure optimal performance and safe for use.
Do not attempt to repair the fan! Kindly return the fan to our
authorized service agent.
If unusual oscillating movement is observed, immediately
stop using the ceiling fan and contact either the
manufacturer, service agent or dedicated qualified persons.
This fan must be mounted at least 3.0m (10ft) above ground.
Disconnect power supply before performing assembly,
disassembly or repair.
It is recommended to examine the fan at least once every 2
years
1.
2.
3.
4.
5.
6.
7.
8.
CAUTION !
UMS 260 AC
250
m
3
/min
3.0
m
3
/min/W

In The Box
Assembly Instruction
Align fan blade hole to the motor and mount
using the M6 screws. Repeat for other fan
blades.
*Use PH2 stubby phillips screwdriver and 10mm
spanner.
Ensure that the safety rope passes
through the fan hook and then securely
fastened using the screw provided.
Safety
Rope
Ceiling
Hook
Fan Motor x 1
Fan Regulator x 1 Fan Blade x 3 Bottom Cover x 1
Middle Cover x 2
Wiring Diagram
L
N
E
Incoming
240V~
Earth
Rotate bottom canopy till
wires slotted in correctly with
minimal gap clearance as
shown.
Screw
NOTE!
The Wires are coloured with
the following code:
(Brown - Live; Blue - Neutral;
Green/Yellow - Earth)
Slide top canopy to the ceiling
and tighten using the screw hole
provided before assembling and
tightening the middle cover.
Remove plastic sleeve from the
thread before tightening the
bottom cover.
*Clockwise direction to fasten
M6 Screw
Double Pole
Switch
*Switch shown not included
Loosen the screw and lower top canopy
to the middle cover and tighten.
Screw Hole
Check gap clearance before tightening
bottom canopy using the bottom screw
holes provided.
Plastic Sleeve
üû
Fan Regulator