Uniden XSA650 User manual

XSA660
AND
XSA650
MANUAL
OWNER’S

CONTROLS AND FUNCTIONS
1. Talk - answers or places calls
2. Mem - stores or recalls numbers in memory
3. Vol/ringer - sets the ringer or earpiece volumes
4. Microphone
5. Talk/batt low - LED indicates when phone is in
use or the battery is low
6. Trans (Model XSA660) - transfers call to the
other Handset
6. Rdl (Model XSA650) - redials the last number
dialed
7. Flash - access to call waiting (if waiting)
8. Numeric key pad
9. Chan - selects another channel for clearer
reception
10. Rdl/pause (Model XSA660) - redials the last
number dialed
10.Pause (Model XSA650) - adds a timed pause in
a memory dialling sequence
Model XSA660 Model XSA650
Please confirm the model
number of your telephone.
Buttons 6 & 10 differ from
that pictured on the Model
XSA650.
*
*
*
*
*

1. Handset Retainer - holds handset in base for
Wall Mounting.
2. Ringer on/off switch - Base Ring ON or OFF.
3. Speakerphone Button and LED - indicates the
phone is in speaker mode.
4. Speaker Volume - Volume up and down Button.
5. Status LED - Indicates the phone is in use or the
handset is charging.
6. Message Counter LED - Display for number of
messages.
7. Recording Time Switch - Select Recording
time.
8. Play/Stop Button - Message Play and stop.
9. Memo Button - Recording a memo.
10. Skip Button - Skip the message.
11. Ring Time Switch - Ring time select switch.
12. Answer Button - answering machine ON OFF
Button.
13. Page Button - locates the handset.
14. Clock Button - Adjust time and day.
15. Mic - Microphone.
16. PIN Button - change PIN number.
17. OGM Button - Out Going Message Recording.
18. Repeat Button - Message Repeat.
19. Delete Button - Delete message(s).

CONNECTIONS
Plug the AC adaptor into a standard
wall socket and make sure it is
switched on.
Plug the AC adaptor cord into the 9V DC
input jack at the rear of the base unit.
BATTERY CHARGE
Plug the battery into each handset.
Place each handset on the base for 15-
20 hours for the battery to fully charge
before you use the phone..
Important Note:
XSA660
and
XSA650
Quick Reference Guide
Start
Start
Here!
Here!
Initial Setting
This page is a very condensed version of your
owners manual and does not attempt to explain
any of the advanced features of your phone.
A simple guide to setting
up your new phone.
✃
Please confirm the model
number of your telephone.
Model XSA660 - Lay both handsets on the base after
charging is complete, for at least 2 seconds to set the
security code.
Only the XSA660 has 2 handsets.

MAKING A CALL
Press the talk button.
The “talk” indicator will stop blinking
when a dial tone is received.
Dial the number and make the call.
To hang up press the talk button or
put handset on base.
RECEIVING A CALL
When the phone rings pick up handset from
base.
OR
Press the talk button if the handset is away
from the base.
OR
Push speaker on the base to use the speaker
phone.
STORING A NUMBER IN MEMORY
Press the mem button on the handset.
Enter the phone number you wish to
store.
Press the mem button again.
Enter the memory location number
where you wish to store the phone
number (0-9).
DIALLING A STORED NUMBER
Press the talk button.
Press the mem button followed by the
memory location number.
To activate the answering machine
press the answer button on the base
until the digital display lights up.
The prerecorded outgoing message will
play.
PLAYING YOUR MESSAGES
Press the play button on the base.
DELETING YOUR MESSAGES
Press delete during the messages: the
system beeps and plays the next
message.
Making/Receiving Calls
Answering Machine
▼
■
Ø
▼
■
Ø
answer
play
delete
speaker
mem