Uniden UH076SX-NB User manual
UH076SX-2NB-TP
UHF-CB Radio
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz
UH076SX-NB
WATERPROOF: JIS7
standard of JIS7.
This Means:
metre for 30 minutes.
The UH076SX-NB will only meet this rating if fully assembled and all
This means that the speaker microphone bung is inserted, and
the battery pack and antenna are attached and securely
fastened.
LITHIUM ION BATTERY PACK WARNING
NOTE
USER LICENSE INFORMATION
operation is subject to conditions contained in those
licenses.
2
Warning
3
Contents
Introduction
Features 4
Included in your Package 5
Controls and Indicators 7
Getting Started
Operation
Monitor 24
CTCSS Codes and Frequencies 25
UHF-CB Channel Guidelines 26
UHF-CB Channels and Frequencies 27
Warranty 29
4
Introduction
situations. To ensure that you get the most from the UH076SX-NB features,
please read this operating guide carefully before using the unit.
FEATURES
2
3
3
installed. The UH076SX-NB will retain its JIS7 rating when the
itself is not splash or waterproof.
Included in your Package
UH076SX-NB
Wrist Strap
UH076SX-NB
NOTE
If any of these items are missing from the box, contact your
place of purchase, immediately.
Mounting Screws
6
Included in your Package
NOTE
If any of these items are missing from the box, contact your
place of purchase, immediately.
Wrist Strap x2
x2
Hang Up Bracket x2
x2
UH076SX-2NB-TP
Optional Accessories
7
Controls and Indicators
2 Beltclip
3 Battery
)
)
H Group Scanning
1/5w
Getting Started
Mounting the Drop-in Charger
(UH076SX-NB Only)
or wall.
Table:
screws and washers.
Wall:
Insert the two mounting screws into the wall
keeping the same space as the holes on the
charger.
through the larger holes then turn the
charger.
the wall outlet and the other end into the
drop-in charger.
When you mount the drop-in charger
cigarette lead instead.
Connect Drop-In Charger with AC Adaptor
the drop-in charger.
OR...
Connect Cigarette Lead Charger
to Cigarette Lighter Jack (UH076SX-2NB-TP)
NOTE
The drop-in charger and cigarette lead charger are not
charger.
Attaching the Antenna
Getting Started
Getting Started
Attaching the Battery Pack
2. Snap the battery release clip until it clicks.
the UH076SX-NB body.
CAUTION
unattached to the radio, in direct sunshine, heated cars, or
to rupture, fail or reduce performance.
In case of exposure to cell contents, wash the affected area
thoroughly, and seek medical attention.
on p.2.
Attaching the Beltclip
the radio. Then slide it up.
attached.
4. To take the beltclip off the radio, turn it
and slid it up.
Getting Started
Charging the Battery Pack
NOTE
For the initial battery charge, make sure the radio is off for
optimum charging.
one UH076SX-NB in the front charging slot and also charge a
-
ing slot. When you charge the 2nd battery, be sure to push it
all the way into the charge slot.
charged.
is no longer illuminated.
Do not transmit when the UH076SX-NB is in the drop-in charger!
drop-in charger.
Getting Started
Battery Level Display
NOTE
When PTT
NOTE
SPKR/MIC Jack Cap
submersible rating.
Battery approx.
NOTE
When charging with the cigarette lead charger the
UH076SX-NB charges slowly and increases to the Battery
for an accurate display.
Conventional Mounting with Screws
the Hang-up Bracket into place with screws.
Conventional Mounting with Double Sided Tape
(not supplied)
Secure the front and back pieces of the Hang-up Bracket using the
Connecting the SPKR/MIC
Mount the Hang-Up Bracket (UH076SX-2NB-TP)
comes in two parts. How and where you choose to mount the Hang-
upBracket will determine which parts to use.
Getting Started
Operation
guide for button and key operations.
Power On/Off
To turn the unit ON, rotate the [ON/OFF VOL]
should appear on the display.
To turn the unit OFF, rotate the [ON/OFF VOL]
knob counter-clockwise. The display will disappear.
Volume
[ON/OFF VOL] knob clockwise or counter-clockwise to adjust
Adjusting the Key Beeps
mon) are pressed.
dup while turning on the radio.
dup while turning on the radio.
Operation
Roger Beep
speaker.
To turn ON Roger Beep: while turning on the
radio.
To turn OFF Roger Beep: while turning on the
radio.
Selecting Channel
or to select the desired channel.
NOTE
If you press and hold the or , channel number will
scroll rapidly.
NOTE
Operation
Squelch
there are no signals present.
NOTE
[SQ] fully
Turn [SQ] fully counter clockwise until you hear a
strong signals.
[SQ] counter-clockwise until you hear noise. Then
turn the [SQ] clockwise just until the noise
stopped. Now only the desired signal can get
through.
NOTE
[SQ] clockwise until the weak signal is heard clearly.
Noise
Weak Signals
Medium Signals
Strong Signals
UH076SX
Operation
To Transmit and Receive
To switch to low power, press 1/5w . LOW
To switch back to higher power, press 1/5w
again. LOW
selected channel.
3. When the channel is clear, press and hold the
PTT to transmit. TX
Hold the radio with microphone approximately
your head. Speak in a clear, normal
PTT and listen for a response. TX indicator
The display shows BUSY when a transmission
Operation
Using a Repeater Channel
shielding effect caused by solid obstructions.
In normal Simplex operation, your radio transmits on one particular
a Tall Building) that partially blocks your transmitted signal, the possibility
structures, etc., tend to act as a screen between radios.
another channel.
duplex mode during transmission, the UH076SX-NB automatically sends
For example:
Operation
To Operate UH076SX-NB in Duplex Mode
dup momentarily. The DUP icon appears.
dup
UH076SX-NB will return to simplex operation.
NOTE
Scanning
To initiate scanning;
scan and scanning starts. SCAN
Open Scan (OS) Mode
NOTE
change or customize the channels by following the steps on
Example: CH80 becomes active
the signal to return, otherwise scanning resumes.
mem momentarily. Scanning resumes.
scan or PTT .
20
Operation
NOTE
starting channel.
Group Scan (GS) Mode
To use GS Mode Scanning, press the os/gs key. GS icon appears on
the display.
NOTE
If GS Scanning is initiated when there are no channels
programmed in GS memory, an error tone will be heard and
scanning will not start.
scanning continues after 3 seconds.
NOTE
scan or PTT .
NOTE
Other manuals for UH076SX-NB
2
This manual suits for next models
1
Table of contents
Other Uniden Radio manuals
Uniden
Uniden Bearcat 880 CHR User manual
Uniden
Uniden MC6700 User manual
Uniden
Uniden UH076SX-NB User manual
Uniden
Uniden PRO505XL User manual
Uniden
Uniden PRO 520XL User manual
Uniden
Uniden Bearcat UBC 248CLT User manual
Uniden
Uniden BearCat BC 855XLT User manual
Uniden
Uniden BC60XLT User manual
Uniden
Uniden PRO530XL User manual
Uniden
Uniden PRO 510XL User manual
Uniden
Uniden Bearcat PC68LTX User manual
Uniden
Uniden PC122AM/SSB User manual
Uniden
Uniden BEARCAT 980 User manual
Uniden
Uniden UH515DLX-2 User manual
Uniden
Uniden PRO 510XL User manual
Uniden
Uniden UH088SX User manual
Uniden
Uniden BEARCAT 680 User manual
Uniden
Uniden PRO340XL User manual
Uniden
Uniden PRO 640XL User manual
Uniden
Uniden PRO 810e Operating and installation instructions
