Uniden FRS1200 Series User manual

Front Cover
frs1200.qxd 3/2/99 10:56 AM Page 1

FCC Information
THIS DEVICE COMPLIES WITH PART 15 OF THE
FCC RULES.OPERATION IS SUBJECT TO THE
FOLLOWING CONDITIONS:
This device may not cause harmful interference.
This device must accept any interference
received, including interference that may cause
undesired operation.
Important: Changes or modifications to this unit not
expressly approved by Uniden could void your authority
to operate this unit. Your radio is set up to transmit a
regulated signal on an assigned frequency. It is against
the law to alter or adjust the settings inside the radio to
exceed those limitations. Any adjustments to your radio
must be made by qualified technicians using the proper
test equipment. To be safe and sure:
Never open your radios case.
Never change or replace anything in your radio
except the batteries.
Your radio might cause TV or radio interference even
when it is operating properly. To determine whether
your radio is causing the interference, turn it off. If the
interference goes away, your radio is causing it. Try to
eliminate the interference by moving your radio away
frs1200.qxd 3/2/99 10:56 AM Page 2

from the receiver. If you cannot eliminate the
interference, the FCC requires that you stop using
the radio.
Do not operate the radio in hazardous
environments. Explosion or fire may result.
Do not operate the radio near unshielded
electrical blasting caps. Under certain
conditions, radios can interfere with blasting operations
and may cause an explosion. Turn your radio OFF to
prevent accidental transmission when in a blasting area
or in areas posted: Turn off two-way radio.
Construction crews often use remote control RF
devices to set off explosives.
Care and Safety: To clean the radio, use a soft cloth
dampened with water. Do not use cleaners or solvents
because they can harm the body of the unit and leak
inside, causing permanent damage. Use a dry, lint-free
cloth to clean the battery contacts. Do not submerge
the unit in water. If the unit gets wet, turn it off and
remove the batteries immediately. Dry the battery
compartment with a soft cloth to minimize potential
water damage. Leave the battery compartment cover off
overnight to ensure complete drying. Do not use the
radio until the unit is completely dry.
frs1200.qxd 3/2/99 10:56 AM Page 3

Controls
1 CHANNEL switch 5 MONI button
2
on/off volume 6 PTT button
3
tx LED 7 Microphone
4
call button
frs1200.qxd 3/2/99 10:56 AM Page 4

1
Welcome . . . . . . . . . . . . . . . . . . . . . . . 2
Optional Accessories . . . . . . . . . . . . . . 3
Battery Installation . . . . . . . . . . . . . . . 4
Low Battery Alert . . . . . . . . . . . . . . . . 5
Belt Clip Installation . . . . . . . . . . . . . . 6
Using Your Radio . . . . . . . . . . . . . . . . 8
Turning the Radio On . . . . . . . . . . . . . . 8
Adjusting the Volume . . . . . . . . . . . . . . . 9
Choosing a Channel . . . . . . . . . . . . . . . .11
Talking on Your Radio . . . . . . . . . . . . . .12
Tone Alert for Incoming Calls . . . . . . . .13
Troubleshooting . . . . . . . . . . . . . . . . .14
Specifications . . . . . . . . . . . . . . . . . . . .16
Contents
frs1200.qxd 3/2/99 10:56 AM Page 1

2
Congratulations on your purchase of the Uniden
FRS1200 series family radio. This product is a
lightweight, palm-sized radio you can carry almost
anywhere. Use it at shopping malls, amusement
parks, or sporting events to stay in contact with
family and friends, or in a neighborhood watch for
vital communication. This compact, state-of-the-
art device is equipped with the following features:
2 Channels
Two-way conversation
1/2 watt output power
Up to 2 mile range*
LED indicator
30 hours of operation**
* Range may vary depending on environmental and/or
topographical conditions.
** 5/5/90 duty cycle
Welcome
frs1200.qxd 3/2/99 10:56 AM Page 2

3
Your package contains the FRS1200 series radio,
this reference guide and the accompanying belt
clip. You will need to purchase 3 AA Alkaline
batteries in order to operate the unit. You may
also purchase the optional carrying case from
your Uniden dealer or by calling [phone]:
Optional Accessories
FRS Unit
Belt clip and screw
frs1200.qxd 3/2/99 10:56 AM Page 3

4
Your FRS1200 series radio uses 3 AA
Alkaline batteries for power.
To install the batteries:
1. Make sure your radio is off.
2. Unlatch the clip
and slide the
battery cover off.
3. Insert 3 AA batteries
according to the
polarity symbols on
the inside of the
battery compartment.
Battery Installation
Do not mix old and new batteries to avoid
damage to the unit.
frs1200.qxd 3/2/99 10:56 AM Page 4

5
4. Replace the battery
cover by pushing it
up until it is secure,
then latch the clip
in place.
When the batteries in the unit are low, the
unit will emit a chirping sound. Replace the
batteries immediately to continue using
the radio.
Low Battery Alert
frs1200.qxd 3/2/99 10:56 AM Page 5

6
Belt Clip Installation
Because you will most likely use your radio
when you are out and about, the unit comes
equipped with a belt clip to securely fasten
the unit to your belt, pocket or purse.
To attach the belt clip:
1. Insert the belt clip
screw into the slot
on the belt clip.
2. Align the screw with
the hole on the back
of the radio and
turn it clockwise,
using a Phillips
screwdriver to
secure the belt clip.
Do not over-tighten.
frs1200.qxd 3/2/99 10:56 AM Page 6