Universal Explore Home 827-966 User manual

INSTRUCTION SHEET
827-966 Media Console
Thank you for purchasing this quality product. Be sure to check all packing aterial carefully for s all
parts that ay have co e loose inside the carton during ship ent.
Caution: (1) These parts are cu berso e and heavy. This product can best be asse bled with the
assistance of one or ore persons in order to prevent personal injury and to insure parts are not da aged
during the asse bly process. If dirty, clean finished parts with ild dishwashing liquid and water solution
applied on da p cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent da age to your floor or carpet, please check the botto of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after re oving the packaging aterial.
The anufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing aterial but be careful not to throw away any asse bly parts or
hardware. Read the instruction sheet and parts list carefully. Re ove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or da aging flooring.
(4) During nor al use everyday, screws, bolts, nuts and wooden plugs ay loosen up. They should be
periodically inspected and re-tightened to prevent da age to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above entioned co ponents is attached to
the furniture properly and kept tightened at all ti es.
PARTS LIST:
#
Description
Qty.
#
D
escription
Qty.
A
Console Top 1pc Leg 4pcs
C
Center support 1pc
D
Long Shelf 1pc
E
Short Shelf 1pc
F
Hardware pack 1bag
Asse bly Procedure : (Please follow the sketches below.)
Step 1: Unpack, inspect, and read asse bly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: put the top (A) upright down on a soft and s ooth surface to avoid da age or being
scratched. Attach the legs (B) to the console top (A) with nut (2), spring washers (3) and flat
washers (4) using wrench (1). And also screw the center support (C) to the botto of dresser
top (A) by hand. Then put the shelves (D & E) in place with shelf pin (5) and wood screw (6)
as below shown.
Note : It is best for two or ore persons are involved.
Assembly is now complete.

INSTRUCTION SHEET
827-966 Media Console
HARDWARE LIST(F)
1
Q'TY
2
1PC
4PCS
5/16"
5/16"
3
4
5
6
5/16"*19
#6*5/8"
4PCS
4PCS
8PCS
5/16"
8PCS
23
4
WRENCH
NUT
SPRING WASHER
FLAT WASHER
SHELF PIN
WOOD SCREW
A
B
C
D
5
6
Step 2
E