Uplift Desk STR017-SHT User manual

Step 2
Connect the Clamp to the Bracket, in the orientation shown,
using two #10-32 Flat head screws and tighten with a Phillips
head screwdriver.
Step 3
Open the clamp as much as needed to t onto the desktop and
slide the assembly all the way onto the desk until it stops.
Clamp the assembly to the desk snugly but be sure not to
overtighten the clamp.
Overtightening can deform the Clamp bracket and cause the
Front and Rear covers to not attach correctly.
Bracket
M5 Hex ange nut
(qty 4)
#10-32 Flat head screw
(qty 2)
Flat wrench
Tray
Pad
Rear coverFront cover Clamp
Step 1
Connect the Bracket to the Tray in the orientation shown. Align
the pem studs (which are attached to the bottom of the Tray)
with the holes in the Bracket.
Screw the M5 Hex ange nuts onto the pem studs, and tighten
using the provided Flat wrench.
Package Contents
Desk Shelf or Monitor Stand, 15 in.
STR017-SHT
draft
© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com

Step 4
Fit the Rear cover in place, inserting the three tabs into the
holes on the Bracket.
Then place the Front cover over the front of the Bracket. Hold-
ing the Rear Cover in place, snap the tabs of the Front cover
into the slotted grooves in the Rear cover.
Step 5
The Pad is optional and can be left off if you choose.
If you decide to use the Pad, you can choose between just set-
ting it on the top of the Tray or permanently attaching it using
the adhesive backing. If you decide to attach it permanently,
peel the lining off of the Pad, exposing the adhesive backing.
Turn it sticky side down and carefully apply the Pad to the top
of the Tray so that it ts evenly into the indentation on the tray
top.
© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com AI-STR017-SHT-1.140030656v.B
Copyright Notice: This guide is a component of this accessory. This guide is a part of the scope of delivery, even if the item is resold. This guide is also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies
may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
CAUTION: Read all instructions before assembly. Failure to assemble properly may result in
damage or personal injury.
CAUTIONS & WARNINGS
!
!