Urban Oasis 708086 User manual

Collapsible Rain Barrel
Parts List: Rain Barrel, Rain Barrel Legs, Drain Spigot, Overow cap.
1A
2A
1D
1B
2B
1E
1C
2C
Installation:
1. Connect the drain spigot to the tting at the
bottom side of the rain barrel.
[See Fig 1A,B]
2. Install the cap on the overow tting at the top
side of the rain barrel
[see Fig 1C]
3. Install the cap and lter assembly on the lid of
the rain barrel
[see Fig 1D,E]
4. Unfold the rain barrel and lay it on its side. Install
the support legs into the built-in sleeves on the
sides of the rain barrel making sure the leg caps
are positioned at the bottom of the rain barrel
[see Fig 2A,B,C]
5. Zipper the lid closed.
Rain Barrel Location:
Note: Choose a downspout that has a level and rm
surface beneath so that the rain barrel will be level.
6. Position the rain barrel under the downspout and
mark the downspout at the midway point from
the top of the rain barrel to the bottom of the
rain barrel. Cur o the downspout at this mark.
[See Fig 3A]
Note: It may be necessary to remove the
downspout from the wall to cut it.
7. Move the rain barrel into position against
the wall on the level surface and insert the
downspout on the wall into the rain barrel. Zip
the lid tightly around the downspout inserted
into the rain barrel.
[See Fig 4A]
Note: The inserted downspout will add stability
to the empty rain barrel until it gets lled with
water. However, it is recommended to add a
couple inches of tap water to the rain barrel for
added weight and stability to prevent movement
by heavy wind etc. Once water is collected in the
rain barrel, it can be emptied through the bottom
spigot or unzip the top and use a watering can.
O Season Storage:
At the end of the season the rain barrel should be emptied and stored
in a heated place in order to prevent freezing or damage to your rain
barrel.
Warning:
Never allow children to play in or around the rain barrel. Always securely
attach the lid to avoid a child drowning.
Never drink water from the rain barrel. Use water from the rain barrel for
watering or outdoor cleaning purposes only.
Always place the rain barrel on a at and solid surface. Check the
downspout does not contain heating cables before cutting when
installing use safety glasses and protective gloves.
4A3A
™

IMPORTANT — PLEASE READ
1Push the tap through the tank, fitting the
rubber washers as shown; one on each side .
Fit the tap upside down tightening as tight
as you can by hand.
AA
2Insert the poles.
3Position on a smooth, flat surface.
Half fill with water. With the spigot in an
inverted position.
4
Twist the tap clockwise to the upright position.
Rotate the spigot clockwise to position with
flow in a downward direction
5Caution: Never drag or move the tank
when it is full of water. The tank should be
completely drained before it is moved.
6 month limited liability warranty against manufacture defect and workmanship.
Punctures and/or dragging product lled with water are not covered by the warranty.