US Steam EAGLE PLUS User manual

!
Steam Fill Tank
Extraction /Detergent
Fill Tank
Steam Pressure
Control Knob
Va c u u m
Extraction
Steam Trigger
Trigger Lock
Power ON/OFF
ON/OFF VACUUM EXTRACTION
Hose Connection
1
Console
Master Power Switch
EAGLE PLUS™STEAM VACUUM
EAGLE PLUS™STEAM VACUUM

1) Add Water
ØRemove grey cap and add tap
water to both tanks
ØEach tank holds one gallon
2) Plug into Electrical Outlet
ØThe EAGLE PLUS™should be
the only appliance plugged into
the electrical outlet
Extension Cord
ØUse only a 12-gauge / 15AMP
rated or higher rated extension
cord
ØMax length: 25ft
3) Power
It will take 10 minutes for the
EAGLE PLUS™to heat up and
reach working temperature
3) Connect the Hose
ØSecure the EAGLE PLUS™
by pushing down the front
brake locks; locking the
wheels will make it easier to
push the hose into the steamer
4) Insert the hose
ØPush until you hear a “click”
5) Steam Control
ØUnlock by pressing RED
button on hose handle
ØSqueeze trigger
6) Adjust Steam Pressure
ØTurn the knob to
Increase or decrease
steam pressure
Quick Start
2
ON/OFF
Master Power Switch
Quick Start
EAGLE PLUS™STEAM VACUUM
ON

Vacuum
ON/OFF
Activate the VACUUM:
ØPushing the button on the
console OR
ØPushing the button on the
hose handle
ØIncrease / Decrease suction
by holding the button
on the hose handle.
The indicator light will change
colors depending on the level of
suction.
Green = Low Suction
Orange = Medium Suction
Red = High Suction
Hot Water Injection / Extraction
The Extraction function will
inject water into the steam.
This function is valuable when
using the extraction nozzles and
floor brushes. The EAGLE
PLUS™becomes an extractor
when combining this function
with the vacuum.
Activate by pushing and
holding the button on
the hose handle, until the
light turns on.
Increase / Decrease water
injection by pushing and holding
the button on the console.
Settings: High / Med / Low 3
Extraction
EAGLE PLUS™STEAM VACUUM
Warning:
To use the vacuum to
soak up water, the
polyester filter must
be removed first.

PROBLEM SOLUTION
Does not turn on when the power
button is pushed
Check the Master Power Switch on the side of the EAGLE PLUS™.
The EAGLE PLUS™should be the ONLY appliance plugged into the
electrical outlet:
ØCheck the fuse box for tripped circuit breaker
ØExtension cord must meet the following requirements:
Ø12-gauge 15AMP rated or higher
Ø25 ft. max length
Alarm is activated
during warm-up
Refill the steam reservoir tank.
ØPush the ON/OFF button on the console to restart the pump
ØIf reservoir tank is full, remove black hose on the side of the reservoir
tank. Water should be dripping from the hose. Replace hose and push
ON/OFF button on the console to restart the pump
Alarm sounds
during use
The EAGLE PLUS™is out of water:
ØRefill both the steam and extraction reservoir tanks
ØPush the ON/OFF button to reset
No vacuum suction
The collection tank is dirty or full.
ØCheck hose for foreign objects
ØCheck and replace filter
No steam when squeezing trigger:
Check the hose connection
ØIs the “lock” activated on the hose handle?
ØAdjust Steam Pressure Knob on front of EAGLE PLUS™
No water is released during extraction
Check the spray nozzle for mineral build up
ØDescale as needed to remove (see manual for instructions)
Error Codes:
Will show on console screen
01 –Refill Steam tank
02 –Refill Extraction tank
03 –Boiler did not refill
05 -Descale boiler
08 -Replace anti-scaling filter
10 –Service required
4
EAGLE PLUS™STEAM VACUUM