Step1: Remove the battery door by loosening the
locking screw using a screwdriver.
Step2: Follow the “+” and “-“markings on the
rechargeable battery, and insert it into the pagers'
battery compartment.
Note: Do not install the battery backwards.
Step3: Put the battery door back and secure it by
tightening the screw using a screwdriver.
Step4: After battery is inserted correctly, the pager
will beep, flash and vibrate simultaneously to show
the pager is powered.
Step 1: Connect the adapter to wall power outlet
(110-240V / 50Hz-60Hz), and connect the adapter
to the charger.
Step 2: When the charger is powered, charger
power LED will illuminate to show it is on.
Step3: Place the pagers on the charger by lining up
the charge contacts and lightly pushing the pager
down into position one on top of the other.
Step4: The pager power LED will go on when the
pager is stacked correctly.
Read
Call
Quic
Guide
Using Your ReadyCall
Battery Installation Charging ReadyCall Pagers
Note: It is suggested that users should implement a system or strategy for rotating pagers being
issued. For example, users might use pagers that have been connected to the charger base for
longer periods of time. This will allow those pagers being returned to have enough time to charge
before being issued to the next recipient.s being issued. For example, users might
