usi KK 6610TP User manual

KK 6610TP MODEL
+
USI
INSTALLATION
MANUAL
INNOVATION

TUS STEAM STERİLİZER INSTALLATION MANUAL
A. OPENNING THE PACKAGING AND PLACING THE EQUIPMENT IN SITE
1. Lift the sterilizer by a fork-lift truch using the lift points and land carefully.
. Open the outer plastic cover on the package.
. Carefully open the main package made of wood.
. Open the inner plastic cover on the equipment .
.
Take the upper panel out.
. Lift the equipment around 15 cm by help of lifting arms on the sterilizer.
. Take the wooden base out.
. Adjust the heights of the floor flanges at the corners so that the sterilizer would be movable
on its casters. (FIG. 2)
9. Move the sterilizer to the installation room.

+USI STEAM STERILIZER INSTALLATION MANUAL
B. MAKING THE ROOM READY AND POSITIONING THE STERILIZER
| KKB610TP SIDE
FIG.3
During positioning of the sterilizer FIG.3 should be considered.
The sterilizer will be levelled by help of floor flanges at the corners, after positioning.

“+ USI STEAM STERILIZER INSTALLATION MANUAL
1. ELECTRIC SUPPLY ;
- 400 V, 3 phase, 50 Hz.
- 45 Kw power.
The Electrical connection will be made as shown in the figure.
2. WATER SUPPLY;
- 3,5 — 5 kg / cm? pressure, %” NPT
- 15-18°C
- 2,5-—5gr. hardness
Water connection will be made as shown in the figure.
3. WASTE ;
- 1-1/2” NPT
- No rezistance to flow ( free fall).
Waste connection will be made as shown in the figure.

+ USI STEAM STERILIZER INSTALLATION MANUAL
4. PRESSURIZED AIR
- 5-6 kg/cm? pressure, %” NPT.
- 300 It./hr. capacity.
Air connection will be made to the conditioner shown in the figure.
C. WARNINGS
1 After positioning the equipment , the lifting arnes on the sterilizer will be with drawn.
! The nuts and screws will be tightened, electrical connections will be checked,
! At the end of installation ;
- The protective plastic covers will be withdrawn carefully.
- The installation area will be cleaned, the packaging woods and plastics will be
thrown to trash.