V-tech switch & go dinos bronco the triceratops User manual

User’s Manual
Bronco the Triceratops
© 2017 VTech
All rights reserved
Printed in China
91-002928-007 UK
®

2
INTRODUCTION
Hi! I’m Bronco the Triceratops. Use my remote control to switch me
and make me race. Hit the turbo boost, and I’ll take off! Let’s go!
Introduction
Switch Button
Turbo Charge
Lever
Talk Button
Sound Button
Style Button
Volume Button Directional
Steering Wheel
Turbo Boost
Button with LED
Light
Button
Remote Control
Power Indicator
Forwards/
Backwards Button
Off/Channel
Switch

3
INCLUDED IN THIS PACKAGE
• OneVTech®SWITCH & GO DINOS®: Bronco the Triceratops
• OneRemoteController
• Oneuser’smanual
• Onelabelsheet
WARNING: All packing materials, such as tape, plastic sheets,
packaging locks and tags are not part of this toy, and
should be discarded for your child’s safety.
NOTE:
1. Please keep the user’s manual as it contains important information.
2. For optimal performance, please use the remote controlled device
on a flat smooth surface.
3. Under the environment with electrostatic discharge and radio
interference field, the sample may malfunction and need user reset
to recover sometimes.
Introduction
LED Headlights
Alignment
Adjust
LCD Screen
Off/Channel
Switch

4
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit and remote control are turned OFF.
2. Locate the battery cover on the bottom of the unit and remote control.
Use a screwdriver to loosen the screw.
3. First, install 6 new AA size (LR6/AM-3) batteries following the
diagram inside the battery box in the main unit. Then, install 2 new
AA size (LR6/AM-3) batteries following the diagram inside the battery
box in the remote controller. (The use of new alkaline batteries is
recommended for maximum performance).
4. Replace the battery cover and tighten the screw in both to secure it.
NOTE: When the batteries run low, the toy will no longer respond. If
this happens, please replace the batteries.
Getting Started
Bronco the Triceratops Remote Control

5
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinre.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specied value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product or
batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com
Battery Notice

6
1
2
3
®
®
®
®
®
®
®
®
LABEL INSTRUCTIONS
Label Instructions
Style 1
8
8
8
7
7
7
1
1
1
3
3
3
5
5
5
2
2
2
4
4
4
6
6
6
Style 2
Style 3

7
Please choose from one of the three label designs to decorate Bronco
the Triceratops. Attach the chosen group of labels to the location on
the product that matches the number next to the label.
Note: It is possible for the front bumper and side panel to get separated
if the unit runs into something with enough force. If this happens,
please reconnect the front bumper and side panel as shown below.
Label Instructions
8
7
1
3
5
2
4
6

8
PRODUCT FEATURES
1. TURN THE UNIT ON
Slide the Remote Control Off/Channel Switch to the
Ior II position to turn the Remote Control ON.
Slide the Off/Channel Switch on Bronco the
Triceratops to the same Ior II position as the Remote
Control. The Remote Control and Bronco the
Triceratops must be on the same Ior II channel to
send and receive signals.
Note: I and II settings are two different channels the Remote Control
and Bronco the Triceratops can operate on. If two units are
operating in the same vicinity, put one unit on channel Iand
the other on channel II.
2. REMOTE CONTROL POWER INDICATOR
After the Remote Control is turned ON, the
Remote Control Power Indicatorwillashto
show the remote is ON. The indicator light will
illuminate anytime a button is pressed, lever is
pulled or the Steering Wheel is turned. The light
indicates a signal is being sent to Bronco the
Triceratops.
3. SWITCH BUTTON
Press the Switch Button to remotely switch
Bronco the Triceratops from dino to vehicle or
from vehicle to dino.
Product Features

9
Product Features
4. TURBO CHARGE LEVER
Move the Turbo Charge Lever up and down to
charge Bronco the Triceratops’ turbo boosters.
When Bronco is fully charged, he says, “charge
complete.”
5. TURBO BOOST BUTTON with LED
If Bronco the Triceratops has been charged
to a level in which he has turbo boost power,
the Turbo Boost Button with LED will blink.
The faster the Turbo Boost Button with LED
is blinking, the more time that will be allotted for
the turbo boost. Once the Turbo Boost Button
with LED is pressed, Bronco the Triceratops
will move at an increased speed.
Note: A turbo boost will last for the duration of the charge level.
If the full turbo boost hasn’t been used while travelling in a
certain direction, you can change direction or switch Bronco
and retain the remaining turbo boost available.
6. FORWARDS/BACKWARDS
By pressing the Forwards/Backwards Button
up/down, Bronco the Triceratops will move
forwards/backwards.
Note:IfyoundBronco the Triceratops is not moving in
a straight line, you can use the Alignment Adjust
to improve.

10
Product Features
7. DIRECTIONAL STEERING WHEEL
When Bronco the Triceratops is moving
forwards/backwards, turn the Directional
Steering Wheel to make him turn left/right.
8. LIGHT BUTTON
Press the Light Button to see the two headlights
illuminate and hear fun sounds and phrases.
9. TALK BUTTON
Press the Talk Button to hear the dino or driver
talk.
10.SOUND BUTTON
Press the Sound Button to hear cool sound
effects.
11.STYLE BUTTON
Press the Style Button to change the dino eyes
or choose a driver.
12.VOLUME BUTTON
Press the Volume Button to adjust the volume.

11
Care & Maintenance / Troubleshooting
13.TURN THE UNIT OFF / AUTOMATIC SHUT OFF
Slide the Off/Channel Switch on the Remote Controller
to OFF to turn it OFF.
Slide the Off/Channel Switch on the Bronco the
Triceratops to OFF to turn it OFF.
To preserve battery life, the Bronco the Triceratops and the Remote
Control will automatically power-off after several minutes without
input.
Note:IfBronco the Triceratops automatically turns off, turn the
unit off and slide the Off/Channel Switch back to the Ior II
position used prior to turn it back on.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit is not in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to
moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
pleasefollowthesesteps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with a new set of batteries.

12
If the problem persists, please call our Consumer Services Department
on 01235 546810 (from UK) or [phone] (outside UK) and a
service representative will be happy to help you.
IMPORTANT NOTE:
Creating and developing VTech®products is accompanied by
a responsibility that we at take very seriously. We make every
effort to ensure the accuracy of the information which forms the
value of our products. However, errors sometimes can occur. It
is important for you to know that we stand behind our products
and encourage you to call our Consumer Services Department
on 01235 546810 (from UK) or [phone] (outside UK)
with any problems and/or suggestions that you might have. A
service representative will be happy to help you.
Company:VTech®Electronics Europe PLC
Address:NapierCourt,AbingdonSciencePark,Abingdon,Oxon,
OX14 3YT.
Phone:01235546810(fromUK),or+441235546810(outsideUK)
Hereby, VTech®, declares that this SWITCH & GO DINOS®: Bronco
the Triceratops isincompliancewiththeessentialrequirements
and other relevant provisions of Directive 1999/5/EC.
Acopyofthedeclarationofconformitycanbeobtainedfromthewebsite:
www.vtech.com/rtte-directive
Note