V-ZUG Komfort 60i KK60i User manual

Installation instructions
Refrigerator Komfort 60i KK60i
Built-in EURO 60
J51048.113-0
16.1.14
1
These installation instructions apply to the following model:
ARaise the appliance using the adjustable feet so that the distance between the top edge of the appliance and bottom edge of the
worktop is 3 mm.
ASlide the appliance in so that the appliance door is flush with the front edge of the adjacent cabinet.
AMount the door panel.
ASlide the appliance in until flush and screw it to the worktop using the enclosed screws.
AFor stone worktops, screw the enclosed lugs to the appliance and laterally to the walls of the niche in accordance with the
instructions.
Validity
Model Type Model no.
Komfort 60i KK60i 51048
Electrical connections
Type Connected wattage Voltage Fuse Cable
KK60i 100 W 220-240 V 6 A 2.5 m
Assembly
The venting ducts in the ventilation grille beneath the appliance door must be kept free (air circulation).
Detailled assembly instructions are enclosed with the appliance.
The door opening can be changed from right to left (incl. freezer compartment door) up until the point when the appliance is
installed in the niche.

Installation instructions
Refrigerator Komfort 60i KK60i
Built-in EURO 60
J51048.113-0
16.1.14
2
Installation guidelines
The appliance is designed for niches with a width of 600 mm (EURO) and a height of 820–870 mm.
AInsert the plug into the mains socket.
ADoor opening angle 105°/90° (with enclosed pin)
A The values for the door panels are recommendations only and may deviate depending on kitchen cabinet manufacturer.
BFor plinth height 100–150 mm (niche height 820–870 mm), leave the plinth strip and ventilation grille.
CFor plinth height 135-185 mm (niche height 820–870 mm), clip out and shorten the ventilation grille.
For plinth height >135 mm (niche height 820 mm), make cut-out in plinth at height of 135 mm.
For plinth height >185 mm (niche height 870 mm), make cut-out in plinth at height of 185 mm.
A plinth recess of 30–60 mm is achieved by pushing back the ventilation grille. For a plinth recess 60–78 mm, put the plinth
panel behind the ventilation grille.
Appliance 597
Niche 600
Shorten
B100…150
C135…185
190 30
Niche 820–870 (max. 890)
0–50 adjustable (max. 70)
Ventilation grille
integrated in plinth
Identificaton plate is
located on left, next-
to salad crisper
Appliance 545
Niche 550
17
220
B
30…60
660
min. 20
Appliance 819–869 (max. 889) a
287 287
289.5 289.5
A
Door panel 595
b
419.3 57
min. 680
aRecommended gap:.3 mm
bRecommended:
70.5 mm
73.5 – a= b
73.5 – 3 = 70.5
Measurements for plinth height 150 mm
Niche
820…870
}