VALCOBABY 954200 User manual
©2017 Valco Companies, Inc. 1
36, 50, 54 INCH FIBERGLASS FANS
54”
954200, 954200-SC, 954201, 954201-SC,
954205, 954206,
954210, 954210-SC, 954211, 954211-SC
954215, 954216, 954240, 954241
954245, 954245-SC, 954246, 954246-SC
954280, 954280-SC, 954281, 954281-SC
954285, 954286
954605-SC, 954606-SC, 954615-SC, 954616-SC,
954640-SC, 954641-SC,
954685-SC, 954686-SC, 954695-SC, 954696-SC
954200-BW, 954210-BW,
954245-BW, 954280-BW
50”
HPM50W340MCAT, HPM50W340MNAT,
HPM50W340MSAT, HPM50W340NCAT
HPM50W420LCAT, HPM50W420LNAT
HPM50W600MCAT, HPM50W610MCAT
HPM50W600MNAT, HPM50W610MNAT
HPM50W650LCAT, HPM50W650LNAT
HPM50W420LNAT-BW,
HPM50W600MNAT-BW
36”
936310
HPM36W340LGAT, HPM36W340LNAT
HPM36W600LNAT
HPM36W760MCAT, HPM36W760MGAT
HPM36W760MNAT
HPM36W280MGA-BW,HPM36W760MNAT-BW
AND DISCHARGE CONES
954184
990150
JDS REV (1) 10-6-2017
©2017 Valco Companies, Inc.
2
Contents
Regulations (Caution and Warning) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
VAL PRODUCTS, INC. PRODUCT WARRANTIES ..........................4
Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
INTRODUCTION ................................... 7
General Information ......................................................7
Assembly INsTRUCTIONs ......................... 10
Fan Assembly ...........................................................10
Galvanized Blade Assembly ..............................................13
Cast Aluminum Blade Assembly ..........................................14
Auto Tensioner Assembly ................................................15
Pulley for Standard Drive Conguration Assembly..........................16
Auto Tensioner Seings / Drive Belt Assembly..............................17
Framing the Wall Opening................................................18
Installing the Fan into the Wall Opening - Internal Mount ...................19
Installing the Fan into the Wall Opening - External Mount (for 54” only).......20
Exterior Install Complete .................................................20
Shuer Installation ......................................................21
DIsChARge CONe Assembly - 54 INCh fAN ONly..... 22
Wiring .................................................................27
APPeNDIXes ..................................... 28
Appendix 1 - Maintenance ................................................28
Appendix 2 - Exploded FAN Overview .....................................30
Appendix 4 - Exploded Interchangeable DRIVE KIT ........................32
Appendix 4 - 54” Interchangeable Drive Kit Parts Lists.......................32
Appendix 5 - Exploded 54” Interchangeable FAN HOUSING ................34
Appendix 5 - 54” Interchangeable Fan Housing Parts Lists ...................34
Appendix 6 - Fan Hardware Packagess .....................................37
Appendix 7 - 54” Fan Blade Parts List ......................................39
Appendix 8 - 50” Fan Parts Lists ...........................................40
Appendix 9 - 36” Fan Parts Lists ...........................................48
Appendix 10 - Fiberglass and Polycones - 50” Fans ..........................52
Appendix 10 - Polycones 36” Fans .........................................52
Appendix 12 - CUSTOMER SERVICE......................................53
©2017 Valco Companies, Inc. 3
Regulations (Caution and Warning)
©2017 Valco Companies, Inc.
4
VAL PRODUCTS, INC. PRODUCT WARRANTIES
VAL-C0®
Val Products, Inc. (Val Products) warrants to the original purchaser that Val Products’ manufactured products (other
than the products subject to an extended warranty set forth below) will be free of defects in material and workman-
-
Explanaons/Condions of above listed footnotes for VAL-CO warranes:
(1)
policy.
(2)
(3)
(4)
-
below.
Normal Warranty
Warranty Coverage
Total Warranty
N/A
N/A
VAL-
©2017 Valco Companies, Inc. 5
-
set forth below.
-
set forth below.
-
1.
2.
the manufacturer.
3. Products not manufactured by Val Products and supplied by outside manufacturers (such as, but not
4.
Val Products does not warrant against feed bin structural failure, or bin unloading components such as
-
-
7.
-
©2017 Valco Companies, Inc.
6
Symbols
ELECTRICAL HAZARD
DISCONNECT POWER
-
-
9.
-
-
©2017 Valco Companies, Inc. 7
INTRODUCTION
• Regular Screwdriver
• Hammer
• 7/16”, 1/2”, 9/16”, 5/16” Open End Wrenches or Socket Wrench with 7/16”, 1/2”, 9/16”, 5/16” Sockets
• WireCuersandStrippers
• 1/8” Hex Key Wrench
• 1/8” Open End Wrench or a 12 Point 3/8” Socket and Ratchet
General Information
©2017 Valco Companies, Inc.
8
Fan Housing and Drive Kit
©2017 Valco Companies, Inc. 9
Fan Housing and Drive Model Descriptions
54” 50” 36”
1
2
-
3
4
- -
- -
-
-
- -
7
ZV774
9
11
12
ZV747
13
- -
14 -
©2017 Valco Companies, Inc.
10
Motor Mount and Rail Assembly
Fan Assembly
for easier assembly.
USE SLOWEST SPEED
WHEN USING POWER TOOLS
Assembly INsTRUCTIONs
Galvanized part numbers
shown - also available in
stainless steel
©2017 Valco Companies, Inc. 11
-
ing inward and through the motor mount tubes or from the inside to the outside. Take care to install the motor
-
lbs.).
to the motor mount tubes.
Motor Mount and Rail Assembly
MOUNTS MUST BE
SqUARE AND LEVEL.
.
.
SqUARE
©2017 Valco Companies, Inc.
12
Shaft and Pillow Block Bearing
-
-
(8.13cm)
©2017 Valco Companies, Inc. 13
Shaft and Pillow Block Bearing
BLADE MUST PROTRUDE
½ “, (1.27cm)
MUST BE CENTERED
.
Blade Assembly
©2017 Valco Companies, Inc.
14
-
.
Aluminum Blade Assembly
Galvanized Blade Assembly
©2017 Valco Companies, Inc. 15
Auto Tensioner Assembly
AachingtheAutoTensionerBracketatthispointwilleliminatehavingtounboltthemotorlater.
NOTE: Motor must be centered.
©2017 Valco Companies, Inc.
16
Pulley for Standard Drive Conguration Assembly
©2017 Valco Companies, Inc. 17
Auto Tensioner Seings / Drive Belt Assembly
rotate tensioner
into place
©2017 Valco Companies, Inc.
18
Framing the Wall Opening
ROUGH OPENING DIMENSIONS
MEASUREMENT
54” Interior 54” Exterior 50” Short Cone 50” Long Cone 36”
ROUGH OPENING
- - - -
©2017 Valco Companies, Inc. 19
Installing the Fan into the Wall Opening - Internal Mount
DOWNWARD SLOPE.
I
your structure, to fasten the fan to the wall.
Detail on installing shuers are on page 21
HOUSING
INSIDE BUILDING
OUTSIDE BUILDING
WALL
©2017 Valco Companies, Inc.
20
USE THE APPROPRIATE SCREWS
IN EACH PRE-DRILLED HOLE AT THE
Exterior Install Complete
Installing the Fan into the Wall Opening - External Mount (for 54” only)
Detail on installing shuers are on page 21
Other manuals for 954200
1
This manual suits for next models
60
Table of contents
Other VALCOBABY Fan manuals
Popular Fan manuals by other brands
Vent Xpress
Vent Xpress PSS 102 installation guide
Hunter
Hunter Mt. Vista installation manual
Bionaire
Bionaire BT38 Instruction leaflet
Ebmpapst
Ebmpapst S3G300-AL11-50 operating instructions
Ebmpapst
Ebmpapst A3G200-AD01-01 operating instructions
Home Decorators Collection
Home Decorators Collection KENSGROVE Series Use and care guide
