Value Leader VL-AM80 Application guide


www. Betstco.com
541-895-3083 M-F 7am-4pm PST
83371 Melton Rd, Creswell OR 97426



VL-AM80 Boom Hedge Cutter

WARING DANGER
VERY IMPORTANT

WARNING DANGER
BEFORE ANY ADJUSTMENT, REPAIR OR CONTROL TO THE HEDGE CUTTER, ALWAYS
STOP THE ENGINE OF THE TRACTOR.

THE MACHINES MUST BE ALWAYS SUPPORTED AND LOWERED WHEN BEING ADJUSTED OR
REPAIRED
BEFORE LEAVING THE DRIVER’S SEAT OF THE TRACTOR, TURN OFF THE ENGINE OF THE
TRACTOR.

CONNECTING THE HEDGE CUTTER TO THE TRACTOR
SEMI-AUTOMATIC HOOK UP TO THE HEDGE CUTTER

TAKING THE HEDGE CUTTER OFF OF THE TRACTOR
WORKING OF THE HEDGE CUTTER
VERY IMPORTANT: THE PTO MUST NEVER EXCEED 540 RPM
WARNING DANGER
ALWAYS adjust your forward speed according to the type of the material to be cut

Reverse the rotor rotation (lever I and L) only when the rotor is completely stopped:
Carrying out this operationn when the rotor is in motion can damage the hydraulic motor

VERY IMPORTANT
NEVER
ALWAYS
USE OF THE MACHINE ON THE ROAD
ATTENTION
ALWAYS
VERY IMPORTANT

WORKING WITH THE HEDGE CUTTER

STORING OF THE MACHINE
VERY IMPORTANT
LEVER AND JOYSTICK SAFETY

MAINTENANCE OF THE MACHINE

HYDRAULIC CONTROLS – CUTTING POSTION
IMPORTANT:
CUTTING HEAD
TRANSIT

ADJUSTMENT OF THE WORKING POSTION
IN THE CASE OF DAMAGE TO THE HEDGE MOWER, CAUSED BY NOT OBSERVING THE
ABOVE MENTIONED INSTRUCTION OF SAFETY, THE MANUFACTURER DECLINES ANY
WARRANTY.
IN THE CASE OF DAMAGE TO A THIRD PARTY CAUSE BY NOT OBSERVING THE ABOVE
MENTIONED INSTRUCTIONS ALL THE RESPONSIBILITIES ARE BOURNE BY THE DRIVER
OF THE VEHICLE.
DO NOT ALLOW UNSKILLED STAFF TO DRIVE THE TRACTOR EVEN DURING
TRANSPORT!

LUBRICATION POINTS
PTO SHAFT
HYDRAULIC OIL
NEVER BE MIXED
VERY IMPORTANT

GEARBOX
PIPES AND HOSES
CABLES AND CONTROL HANDLE
CUTTING HEAD
INDIRECT TRANSMISSION ROTOR:
BEFORE STORAGE
INDERECT TRANSMISSION ROTOR: