Van Walt YSI Pro Plus User manual

Van Walt Ltd | Prestwick Lane | Grayswood | Haslemere | Surrey | GU27 2DU | Tel. [phone] | Fax. [phone] | www.vanwalt.com
QUICK START GUIDE: YSI Pro Plus Water Quality Meter
[phone]
VAN WALT
Monitoring your needs
This guide serves as a quick reference
for operating a YSI Pro Plus. It is for
your convenience & not intended to
replace the full-length manual where
additional information may be found.
RR102V6_07/06/2018_JI
This unit was calibrated on the day we sent it to you. (See Calibration Certicate)
1. Attach the Quattro Cable to the YSI meter.
2. Removecalibrationcup&attachprobeguardorowcelloverprobes.
a. If using probe guard, carefully & slowly lower the probe end of the
cable to required height in the well.
 b. Ifusingtheowcell,attachtopump&begintopumpsample
  throughtheowcell.PleaseensurethattheFlowCelliskeptup
right by using our Van Walt base plate located in the Peli case, will
cause inaccurate readings if left horizontal.
3. Green button to turn on/off meter.
4. Press: PROBE -> DISPLAY to show desired sensor reading on screen. Allow 5 -
10 minutes for DO probe to warm up.
Logging
1. Press:FILE->SITELIST->ADDNEWtocreatepersonalsite.
2. Press:SYSTEM->LOGGING->CONTINUOUSMODEtobeginautomatic
interval logging.
3. Press:ENTERtobeginlogging.
4. Press: SITE in drop down menu to select your personal site.
5. Pres:ENTERtostoplogging.
6. Press:FILE->VIEWDATAtoviewdata.

Van Walt Ltd | Prestwick Lane | Grayswood | Haslemere | Surrey | GU27 2DU | Tel. [phone] | Fax. [phone] | www.vanwalt.com
QUICK START GUIDE: YSI Pro Plus Water Quality Meter
[phone]
VAN WALT
Monitoring your needs
Calibrating your YSI Pro Plus
Please contact Van Walt if you wish to calibrate your YSI.
Spot Checking
Wewouldrecommendaqualityspotchecktoensurethebestresults.Usedsolutions
will be charged for. Do not return any opened bottles of solution. Please call us for
help or guidance.
Problems
Please contact Van Walt if you have any problems.
When not in use
1. Please store your YSI in a warm dry place. Please do not keep the YSI in peli-
case if inside of peli-case is very wet.
2. Whennishedwithunit,pleaserinseprobes&llthecalibrationcuptothe
mark (approx. 1 cm) with tap water (deionised water should never be used
 forstorage!).Fitcalibrationcupbyslidingitovertheprobes&screwingright
until hand tight.
Scan to download the video
YSI Display & Logging