VanEssa mobilcamping 00001668 User manual

Installation guide
Swivel seat bracket
(co-driver)
-
VW
T5 / T6 / T6.1
*Attention:
The swivel seat bracket can only be used at the co-driver‘s
seat without significant change within crucial parts of the
van.
For a swivelling driver‘s seat, please consult your car dealer.
The passenger seat should not be electrically adjustable.

Pull the key in order to avoid trouble codes after
un- and re-plugging the seat electrics.
1.
2.
Take down the cap on the passenger seat at the
back.
Note:
On the T6.1, the interior lighting must be unplugged at the
cap (pic. 1 + 2).

Move the co-driver‘s seat completely to the
back and unscrew the front screws (pic. 3).
3.
Move the co-driver‘s seat completely to the
front and unscrew the aft screws (pic. 4 + 5).
4.
5.

Carefully tilt the seat over to the back while
watching out for the seat‘s electric cables.
Do not remove the seat completely (pic. 6).
Tip:
It is best to have a second person hold the seat while tilting
it back.
6.

7.
Unplug all cables and memorise where they
were plugged in (pic. 7).
Tip:
You can take a picture of the cables.

Then carefully lift the seat down (pic. 8).
Note:
The original seat screws are no longer needed.
8.

Place the swivel bracket on the seat mount and
thread the cables through the hole in the center
of the swivel bracket (pic. 9).
Then rotate the top plate a little bit to get
better access to the screws.
9.
Note:
To rotate the upper plate, pull the white lever upwards
(pic. 10).
10.

Fasten the swivel bracket on the seat bracket
with the screws sent along and twist the upper
plate back (pic. 11 + 12).
Tip:
Tighten the screws only slightly at first until all four have
bitten.
11. 12.
13.

14.
Place the seat on the swivel seat bracket.
Do not place it completely on the seat bracket
yet, but first plug the cables back in at the right
place (pic. 13 + 14).
15.

16.
Mount the seat with the enclosed screws and
one lining disk each (pic. 15 + 16).
Tip:
If you turn the swivel bracket and seat a little, it will be
easier to install the screws.
17.
If you still want to use the original back cover
of the seat pan, cut o the part right of the red
line (pic. 17).