Vanraam Chat User manual

[phone]
[email protected]
www.vanraam.com
Version 21.01
Van Raam
Guldenweg 23
7051 HT Varsseveld, The Netherlands
Chat Protection Screen
Assembly Instructions
Protection Screen

2/7
Version 21.01
Contents
Contact details manufacturer .................................................................................................................... 2
Conformity........................................................................................................................................................ 2
Introduction...................................................................................................................................................... 3
Assembly of the protection screen .......................................................................................................... 4
Contact details manufacturer
Conformity
Van Raam, the manufacturer, declares that the tricycles as described in this user manual
have been produced conform Regulation (EU) 2017/745, risk class 1. Furthermore, the
products also conform to directive 2006/42/EG. The declaration of conformity can be
found on the Van Raam website.
[phone]
[email protected]
www.vanraam.com
Van Raam
Guldenweg 23
7051 HT Varsseveld, The Netherlands

3/7
Version 21.01
Introduction
This user manual lays out important and necessary information
regarding the assembly and the use of the protection screen. We
request you to carefully read this user manual before using the
product. Always follow the instructions as documented in this
user manual.
In case this product will be used by minors, or people with reduced mental capacity. All
safety and user aspects in this user manual have to be clearly explained by a responsible
supervising person.
READ CAREFULLY

4/7
Version 21.01
Assembly of the protection screen
Step 1:
Remove all cushions from the
seat. Release and lower the
footrest in order to open the
buttons at the bottom of the seat
Step 2:
The opening next to the seat belt
attachment points is now clear.

5/7
Version 21.01
Step 3:
A small luggage compartment is
located behind the seat. There is
an opening to the front of the
seat at the bottom of this
compartment. Push the elastic
rope and hook through the
opening until it reaches the front
of the seat.
Step 4:
Place the cushions back onto the
seat. Pull the elastic rope and the
seat belts through the opening in
the middle of the cushions. Clamp
the hook onto opening [5].
Step 5:
Attach the elastic rope to the
frame at the back of the seat. The
clip can be used to create a loop
in order to alter the tension of the
elastic rope.
Step 6:
Now you can attach the
protection screen to the top of
the canopy.

6/7
Version 21.01
Step 7:
At the back of the canopy, pull
the cord around the frame from
the bottom upwards and clamp
the hook onto opening [3].
Step 8:
Repeat step 7 at the front of the
canopy. Clamp the hook onto
opening [1].
Step 9:
Open some buttons of the canopy
in order to make way for the
elastic rope.
Step 10:
Pull the rope back around the
frame.

7/7
Version 21.01
Step 11:
Clamp the hook at the end onto
the opening [4]. The clip can be
used to create a loop in order to
alter the tension of the elastic
rope.
Step 12:
First release and lower the
footrest. The rope that is
attached to the opening [6] can
now be attached to the horizontal
bar that became visible.
Caution! If the protection screen
is not properly tensioned, you can
use opening [7]. This can occur
with previous models of the
canopy.
Step 13:
The clip can be used to create a
loop in order to alter the tension
of the elastic rope. This way you
can tighten or loosen up the
elastic rope.