Vax V-2000 U User manual

User Guide
vax.co.uk
GB
Vax Careline 0844 412 8455
Bagless Upright
V-2000 U
Get Cleaning...
What’s your Vax’s model number?
What’s your serial number? (Located on the base of the machine)
ote these down in case you need them in future. Please keep instructions for further use.
U90-VU Series
U 9 0 –V U – –
– – – – –
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 1

---
Machine Overview
Unit
2 Vax Careline
0844 412 8455
2
4
1
5
6
7
12
13
Filters
16 Central HEPA filter
Accessories
17 Pre motor filter 18 Crevice tool
3
19 2-in-1 tool 20 TurboTool (some machines only)
9
8
10
1 Handle
2 TurboTool (some models only)
3 Dirt bin release button
4 Carry handle
5Central HEPA filter
6 Dirt bin
7 Carpet height adjust
8Hose to machine connector
9 Extension wand
10 Crevice tool
11 2-in-1 tool
12 Hose
13 Release pedal
14 On/off pedal
15 Carry handle
14
11
15
16
17
18
1920
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 2

General Safety Information
vax.co.uk 3
F R H USEH LD USE NLY.
When using the vacuum cleaner, basic safety precautions
should always be observed, including the following:
1. Only use the vacuum cleaner indoors on dry
surfaces.
2. Turn off the vacuum cleaner controls before
disconnecting or connecting from the mains supply.
3. Always unplug the vacuum cleaner before
connecting or disconnecting the vacuum hose and
accessories.
4. Children should be supervised to ensure that they
do not play with the appliance.
5. This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
6. Use only as described in this manual. Use only Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been
dropped, damaged, left outdoors or dropped into
water. Do not use the vacuum cleaner with a
damaged cord or plug. If the supply cord is
damaged return the vacuum cleaner to a Vax
Authorised Service Agent or contact the Vax Careline
on 0844 412 8455 for assistance.
8. Do not pull or carry by cord. Do not use the cord as a
handle, close a door on the cord or pull cord around
sharp edges or corners. Do not run the vacuum
cleaner over the cord. Keep the cord away from
heated surfaces.
9. Do not handle the plug or vacuum cleaner with wet
hands. Do not use outdoors or on wet surfaces.
10. Do not put any objects into openings. Do not use
with any openings blocked and do not restrict air-
flow. Keep all openings free of dust, lint, hair or
anything that might reduce airflow.
11. Keep hair, loose clothing, fingers and all parts of
the body away from openings and moving parts.
12. Do not pick up hot coals, cigarette butts, matches
or any hot, smoking or burning objects.
13. Do not pick up flammable or combustible
materials (lighter fluid, petrol, kerosene etc.) or use
in the presence of explosive liquids or vapours.
14. Do not vacuum up harmful or toxic material
(chlorine, bleach, ammonia, drain cleaner etc.).
15. Do not vacuum up hard or sharp objects such as
glass, nails, screws, coins, etc.
16. Do not use without ALL of the filters in place.
17. Take extra care when vacuuming on stairs.
18. Keep vacuuming area well lit.
19. Store the vacuum cleaner in a cool, dry area.
20. Turn off the on/off switch before unplugging the
vacuum cleaner
21. Use only CE-approved 13 amp extension cords.
on-approved cords may overheat. Care should
be taken to arrange the cord so that the cord
cannot be tripped over.
WARNING: Always switch off and unplug the
vacuum cleaner from the electrical outlet before
assembling, opening or emptying the dirt container, or before
connecting/disconnecting the attachments.
CAUTI N: The vacuum cleaner is a very powerful
unit. Before plugging the cord into the electrical
outlet, make sure the switch is in the ‘off’ position.
IMP RTANT: If the inlet, hose or telescopic tube
is blocked, switch off the vacuum cleaner and
remove the blockage(s) before re-starting the vacuum
cleaner. See Maintenance: Clearing blockages.
IMP RTANT: Washing filters improves vacuum
performance. Vax recommends that they should
be checked and cleaned periodically (depending on the level
of use). Make sure all filters are completely dry before
inserting back into the vacuum cleaner.
IMP RTANT: The motor is equipped with a thermal
cut-out. If for any reason the unit should overheat,
the thermostat will automatically turn the unit off. Should this
occur, unplug the vacuum cleaner from the electrical outlet
and turn off the switch. Remove dirt container and empty.
Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical outlet and switch back
on.
This vacuum cleaner is intended for household use
only and N T for commercial or industrial use.
PLEASE KEEP INSTRUCTI NS F R FURTHER USE.
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 3

---
Operation
Assembling your vacuum cleaner
4Vax Careline
0844 412 8455
Keep your Vax like new
IMP RTANT: The condition of the filters affects the
performance of your machine. Please check and clean
filters periodically (depending on the level of use). For full
cleaning instructions, see page 6.
!
IMP RTANT: Do not use the vacuum cleaner without
all of the filters in place.
!
N TE: Do not over-
tighten screw.
Please align arrows to
lock/unlock dirt bin lid
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 4

Operation
vax.co.uk 5
perating the appliance
Carpet height adjustment
Using accessories
N TE: In upright position adjust knob
to appropriate setting.
IMP RTANT: When the vacuum
cleaner is stood in the upright
position or when using the hose and tools,
the carpet height adjuster must be set to
the highest position.
!
N TE: The crevice tool and 2-in-1 tool can both be attached to the extension wand or directly
onto the hose
Turn unit on/off Recline unit
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 5

---- ---
Maintenance (Keep your Vax as good as new)
6Vax Careline
0844 412 8455
Cleaning the filters
tap
24
tap
Emptying the dirt container
24
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 6

Maintenance (Keep your Vax as good as new)
vax.co.uk 7
N TE: Loop the new belt first over the motor drive shaft and then over the brushbar. Insert the
right side of the brushbar first then the left. Ensure brushbar is entered completely before replacing
vacuum head and replacing the five screws.
Changing the belt
Removing blockages from the brushbar
IMP RTANT: If the
problem persists then
follow instructions above to
gain access to the brushbar.
Removing blockages from the TurboTool
!
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug
from the electrical outlet before performing any maintenance/troubleshhooting checks.
!
Remove
Disconnect the hose from the vacuum cleaner and remove any blockages found then reconnect
the hose securely.
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 7

---
8Vax Careline
0844 412 8455
FAQs
!
WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner
before performing maintenance/troubleshooting checks.
Is there an accessory missing?
• Check the ‘Machine Overview’ page in this guide
to make sure the part is definitely included in your
unit.
• If it is missing, we’re here to help. Simply call us on
0844 412 8455
Why won’t the vacuum cleaner pick up?
• The filters may be clogged: Refer to the
Maintenance sections (Page 6).
• The Dirt Container is full or blocked: Refer to
the Maintenance sections (Page 6).
• The Dirt Container may be incorrectly installed:
Refer to the Maintenance sections (Page 6).
• The brushbar may be blocked. Refer to the
maintenance section (Page 7).
Why is dust escaping from the vacuum?
• The filters may not be installed correctly. Refer to the
Maintenance sections (Page 6).
• The Dirt container may be incorrectly installed:
Remove the Dirt Container from the unit by
pressing the Dirt Container Release Button (Page
6) and reattach it to the unit, ensuring it is locked
firmly back into place.
• The filters may be clogged: Refer to the
Maintenance sections (Page 6).
What do I do if an accessory/the unit becomes
damaged or broken?
• Visit www.vax.co.uk for parts and spares.
• Please call our Vax careline to purchase new
spares or order a replacement:
0844 412 8455
Why won’t the accessories pick up properly?
• The accessory may be blocked: Refer to the
Maintanance section (Page 7).
• The accessory may be faulty: call our
Vax Careline to order a replacement:
0844 412 8455
Why will the vacuum cleaner not run?
• It may not be plugged into the electrical outlet
correctly. Ensure that the plug is pushed into the
electrical outlet securely.
• The electrical outlet may not be working. Check the
fuse or breaker and consult an electrician.
• The motor Thermostat may have tripped. Switch
off and unplug the vacuum cleaner. Leave for one
hour before switching the vacuum cleaner back
on.
Why isn’t my brushbar rotating?
• The brushbar may not be turned on. Refer to the
operation section (Page 7).
• The unit may not be reclined. Refer to the
operation section (Page 4).
• The brushbar may be jammed. Refer to the
maintenance section for how to reset the brushbar
(Page 7).
Why is there a red light on the nozzle?
• The brushbar may be jammed. Refer to the
maintenance section for how to reset the brushbar
(Page 7).
• If the red light still shows, we’re here to help.
Simply call us on 0844 412 8455
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 8

vax.co.uk 9
Other information
UK Service & Help
Vax Customer Careline 0844 412 8455
Monday-Friday 8.30am to 6.30pm
Saturday-Sunday 9.00am to 5.00pm
If you have any queries about using your Vax, call the Vax Careline. Calls are charged at the UK
national rate.
Please make a note of the serial number and model number of the carpet cleaner before calling.
There are over 400 approved Vax Service Agents in the UK. For the nearest Service Agent, please
call the Vax Customer Careline or visit vax.co.uk
Technical Specification
Voltage: 220 – 240V
Wattage: 2000W
Capacity: 3L
Filters: Central HEPA antibacterial filter
Pre-motor filter
Cord length: 7m
Weight: 6.9kg
Subject to technical change without notice.
EEC Statement of Compliance
Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the
U90-VU Series is manufactured in compliance with the following Directives:
Safety: 2006/95/EC Low Voltage Directive
EMC: 2004/108/EC Electromagnetic Compatibility Directive
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 9

-- ---
Vax Ltd., Kingswood Road, Hampton Lovett, Droitwich, Worcestershire, WR9 QH, UK
email: [email protected] - website: vax.co.uk
U90-VU-Series User Guide:User guide 24/11/2009 13:18 Page 10