Vax VO-3000 Product information sheet

Easy Guide
UK SERVICE & HELP - VAX CARE 0870 6061248
Monday to Friday 9.00am to 5.00pm. An answer phone is available out of these hours. If you have queries or concerns about using your VAX, call the HELPLINE. Calls are charged at
the UK national rate. Please make a note of the serial number and model number of your VAX before calling. There are over 400 approved VAX Service Agents in the UK. For your
nearest Service Agent, please call VAX Care.
VO-3000
Please read carefully before using your VO-3000

Parts check list
A- Carry handle
B- On/Off button
C- Motor housing unit
D- Cord winding recess
E- Release latches
F- Vacuum hose connector
G- Blower hose connector
H- Dust/dirty water container
I- Flexible hose
J- Floor tool
K- Hand tool
L- Extension tubes (3)
A
E
G
F
H
B
C
D
I
J
K
L

1
2
Preparing to use
Fig. 1 Remove the top of the vacuum by releasing the side latches.
Fig. 2 With both latches released, lift the top section away as shown.

4 5 6
How to assemble
Fig. 3 Remove tube sections and tools from inside the vacuum cleaner
Fig. 4 Assemble the three piece extension tubes and the floor tool by pushing them together
as shown.
Fig. 5 VACUUM - Insert flexible hose into hole labelled 'vacuum'
Fig. 6 BLOWER - Insert the flexible hose into the hole labelled 'blow'
3

78
How to use
Fig. 7 Fully unwind the mains cable and plug it into a standard domestic socket outlet.
Fig. 8 To start the vacuum cleaner, turn the power switch on. To stop, turn the switch off.

9
10
Operating your cleaner
Dry
Fig. 9 Ensure black fibre filter bag is fitted and secured using the elastic band supplied.
Wet
Fig. 10 Remove black fibre filter bag, exposing safety float chamber.

11
12
Operating your cleaner
Fig. 11 Floor tool is suitable for wet or dry use.
Fig. 12 Hand tool is suitable for wet or dry use.
Important
- Ensure there is no remaining water in the hose and tubes before switching off the appliance.

13 14 15
Emptying the dust container/dirty water container
Fig. 13 Unclip release latches.
Fig. 14 Lift out motor housing unit.
Fig. 15 For dry - empty dust and debris directly into the bin.
For wet - tip the dirty water down sink or drain, rinse out the container.

Cleaning the filter
Motor protection filter
Fig. 16 The black fibre filter bag is located on the underside of the top section of your VO-3000 and protects
the motor from dust and debris during dry vacuuming.
Fig. 17 This filter can be removed and lightly swilled under cold water to remove any debris. Ensure it is completely
dry before replacing.
Attention: The black fibre filter bag must always be used when dry vacuuming.
16 17

18 19
Storage
Fig. 18 Tube sections and tools can be stored inside the vacuum cleaner.
Fig. 19 When not in use, the flexible tube can be stored as shown.