Vegepod Medium Trolley Stand User manual

** SEE OUR WEBSITE FOR STEP BY STEP ASSEMBLY VIDEOS **
https://vegepod.com.au/pages/assembly-videos
Stand/Trolley Assembly Instructions
Medium 1m x 1m
Component Checklist
Legs
4
Angle cross braces
With holes
2
Angle cross braces
No holes
2
Cross brace tube
2
Corner brace
4
Long Bolts
M6*55
8
rounded head
Medium Bolts
M6*45
4
Short Bolts
M6*16
16
Nuts
28
Large Bolts
4
Angle trolley
support
2
Tube for Trolley
base
2
Castor wheels
+ rubber caps
4
Allen keys
2

Assembly
IMPORTANT *****
ENSURE STAND TROLLEYS ARE ONLY USED ON FLAT, HARD LEVEL
GROUND
The wheels will not work on soft areas.
Once filled with soil the Vegepods are very heavy. So please ensure the wheels are
locked and secure.
1. Select the 2 ‘angle cross braces with holes’(
that have 2 holes in the middle of them). Lay
them on the ground with the side with the
middle holes flat on ground.
2. Place ‘cross brace tubes’ so the holes line up.
Select 4 mid-size bolts with rounded head.
Feed bolt upwards so it sticks out the top of the
cross brace tube, then screw nut on till finger
tight.
3. Select the 4 corner braces. Attach long angle
cross braces to the inside of the corner braces using
SHORT bolts. Make sure the longer side of the corner
brace is pointing up (you are making this upside down
for now) –Just finger
tight for now.
You should now have this

4. When you have bolted both the 2 long angle cross braces with holes to the
corner braces then slide the last 2 angle cross braces in(on top of other cross
braces) and bolt those to the corner braces.
5. Bolt legs to the Corner Brace using the LONG bolts and tighten. Rotate the legs to
line the holes up.
(*important –also ensure the holes at the bottom of the legs are aligned
lengthways. The tube for Trolley base will be positioned between these
holes.)
Using the long bolts, push
them through the
holes, then add nut and do
up finger tight.

6. Place angle trolley support piece on legs lining up holes. Rest there while you pick up
a trolley tube. Now get a large bolt and push through angle trolley support and leg
and then twist on the trolley tube. Do the same to the other end and tighten with the
largest allen key.
7. Repeat process for other side.
8. Grab a castor wheel and put the lock on. Now feed the bolt into the bolt hole and
turn to tighten all the way. Repeat for all wheels
9. Place rubber caps on top of exposed thread to prevent rusting
10.Tighten all bolts with allen keys