Vegepod Vegecover-Medium User manual

Trademark Patent Copyright
Support
Email: [e-mail]
Phone: [phone]
Assembly Instructions
Vegecover - Medium
.
IMPORTANT
** Ensure longer ends of arch poles are at bottom
*** Assemble on a hard surface
Ensure all pieces are fully inserted into plastic connectors. Lay the
frame on its side using the ground to gain more leverage, you may even tap
lightly with a mallet or hammer.
To check if they are fully inserted place the frame on top of the assembled
Vegepod, the frame should sit directly over the ‘hinge clips’ or 10mm smaller
than top rim of Vegepod.

Trademark Patent Copyright
Cable tie (6) - hinge clip (6) - ratchet clip (1) - string
Sprinkler Line (1)
Hose connection (1)
*Before attaching greenhouse material
Watering System
Attach the 2 pieces of black polypipe together
1. Connect the hose outlet to the main sprinkler line by
pushing the elbow into the open end of the black
polypipe. Push on as far as it will go (well over the
barbs). **If this proves difficult heat the end of the pipe
with boiling water. Put ratchet clip on and tighten clip
with fingers so that it is past the barb in the elbow.
Tighten clip with pliers. The direction can be turned
later when putting cover on.
HINT: Use boiling water to soften pipe allowing easy
insertion of fittings
2. Attach Sprinkler Line (spray nozzles) to the inside
top of the frame using the longer Cable Ties.
Working along - tie to the top of frame every
15cm or so with a cable tie until secure. To make
these ties tight you can squeeze the pipe as you
pull the cable tie. Twist pipe to ensure sprinkler
heads are pointing down in the same general
direction. Tighten cable ties with pliers if it looks
like it may move around.
HINT: Slightly crush polypipe while tightening
cable ties. Also align sprinklers to point straight
down.

Trademark Patent Copyright
3. Line up Greenhouse Cover Material with seams to
go over arches. Making sure the outlet hole is
lined up with the hose connector. Make sure
seams and Velcro are on the inside.
4. Gently pull cover down over frame, then turn
the cover over. Separate (open) the Velcro.
Push hose outlet through opening.
5. Continue to pull cover up now until one strip of
the Velcro is pulled above the base of the frame.
Attach Velcro around frame.
HINT: Make sure outlet hole is at the same end
as hose connector.
HINT: After pulling cover material over frame –
turn the frame upside down –this makes
attaching velcro much simpler.
6. Remove several clips along one side from top of
panels by sliding them out of the Vegepod garden
container rim. Push in Hinge Clips on both ends
ensure clips slides over the back lip to ensure it
cannot slip back out (require to push hard). Push
the steel frame cover base with material around it
into the hinge clips (it will click in firmly). The
material will eventually wear on these hinges but
it will not affect performance.
It is advisable to also put hinge clips on opposite
side to lock the Vegecover shut.
Hinge clip
HINT: Use hinge clips on opening side also to
ensure the cover can clip shut in case of high
winds.
7. If the Vegecover (when open) is not resting on
something behind then use the string to tie it and
stop it opening too far. If the lid is opened past 90
degrees the frame will pop out of the hinge clips.
Tie string from corner of frame (feed through
cover material close to frame) to dress clip or
closing hinge clip to prevent this from happening.