Vegepod Small Trolley Stand User manual

** SEE OUR WEBSITE FOR STEP BY STEP ASSEMBLY VIDEOS **
https://vegepod.com.au/pages/assembly-videos
Component Checklist
Legs
4
Angle cross braces(long)
2
Angle cross braces(short)
2
Cross brace tube
2
Corner brace
4
Long Bolts
M6*55
8
Medium Bolts
M6*45
4
Short Bolts
M6*16
16
Nuts
28
Large Bolts
4
Angle trolley support
2
Tube for Trolley base
2
Castor wheels
+ rubber caps
4
Allen keys
2
Stand/Trolley Assembly Instructions
Small 1m x 0.5m

Assembly
IMPORTANT *****
Trolleys should only be used against a structure.
If exposed the trolley is susceptible to tipping in high wind
ENSURE STAND TROLLEYS ARE ONLY USED ON FLAT, HARD LEVEL GROUND
The wheels will not work on soft areas.
Once filled with soil the Vegepods are very heavy. So please ensure the wheels are
locked and secure.
1. Select the 2 ‘angle cross braces - long (that
have 2 holes in the middle of them). Lay them
on the ground with the side with the middle
holes flat on ground.
2. Place ‘cross brace tubes’ so the holes line up.
Select 4 mid-size bolts with rounded head.
Feed bolt upwards so it sticks out the top of the
cross brace tube, then screw nut on till finger
tight.
3. Select the 4 corner braces. Attach these to your angle cross braces on the inside of
the corner braces using SHORT bolts. Make sure the longer side of the corner brace is
pointing up (you are making this upside down for now) –Just finger tight for now.
4. When you have bolted both the 2 long angle cross braces with holes to the corner
braces then slide the last 2 short angle cross braces in(on top of other cross braces)
and bolt those to the corner braces.
This is what you should have

5. Then place legs into corner braces so holes line up.
(*important –also ensure the holes at the bottom of the legs are aligned
lengthways. The tube for Trolley base will be positioned between these
holes.)
Using the long bolts, push them through the holes, then add nut and do up finger
tight.
6. Place angle trolley support piece on legs lining up holes. Rest there while you pick up
a trolley tube. Now get a large bolt and push through angle trolley support and leg
and then twist on the trolley tube. Do the same to the other end and tighten with the
largest allen key.
7. Repeat process for other side.
8. Grab a castor wheel and put the lock on. Now feed the bolt into the bolt hole and
turn to tighten all the way. Repeat for all wheels
9. Place rubber caps on top of exposed thread to prevent rusting
10.Tighten all bolts with allen keys