Vegepod Small Stand User manual

** SEE OUR WEBSITE FOR STEP BY STEP ASSEMBLY VIDEOS **
https://vegepod.com.au/pages/assembly-videos
Stand Assembly Instructions
Small 1m x 0.5m
Component Checklist
Legs + plastic end caps
4
Angle cross braces(long)
2
Angle cross braces(short)
2
Cross brace tube
2
Corner brace
4
Long Bolts
M6*55
8
Medium Bolts
M6*45
4
Short Bolts
M6*16
16
Nuts
28
Allen keys
1

Assembly
IMPORTANT *****
ENSURE STANDS ARE ON FLAT LEVEL GROUND
If placing the stands on lawn or soft surfaces - Ensure the legs are placed on
footings made from pavers or bricks that are level to prevent the legs sinking into
the earth.
Once filled with soil the Vegepods are quite heavy. So please ensure stand is
secure, stable and flat before filling with soil.
1. Select the 2 ‘angle cross braces - long (that
have 2 holes in the middle of them). Lay them
on the ground with the side with the middle
holes flat on ground.
2. Place ‘cross brace tubes’ so the holes line up.
Select 4 mid-size bolts with rounded head.
Feed bolt upwards so it sticks out the top of the
cross brace tube, then screw nut on till finger
tight.
3. Select the 4 corner braces. Attach long angle cross braces to the inside of the corner
braces using SHORT bolts. Make sure the longer side of the corner brace is pointing
up (you are making this upside down for now) –Just finger tight for now.
4. When you have bolted both the 2 long angle cross braces with holes to the corner
braces then slide the last 2 short angle cross braces in(on top of other cross braces)
and bolt those to the corner braces.
This is what you should have

5. Then place legs into corner braces so holes line up. Using the long bolts, push them
through the holes, then add nut and do up finger tight.
6. Push in plastic feet and tighten all bolts