Velodyne SC-IF/IC User manual

SC-IF/IC
(In-Floor/In-Ceiling)
Subwoofer
SubContractorTMSeries
INSTALLATION
MANUAL

i
.www.velodyne.com SC-IF/IC User’s Manual
Caution

ii
.www.velodyne.com SC-IF/IC User’s Manual
Table of Contents
Product Overview.................................................................................................1
Installation — Step-By-Step ....................................................................................2
Other Velodyne Products.....................................................................................10

Product Overview
1
.www.velodyne.com SC-IF/IC User’s Manual
The SC-IF/IC (In-Floor/In-Ceiling) is the first floor/ceiling sub to deliver true reference quality
performance. The SC-IF/IC sports a powerful 12” driver and expanded sealed cabinet enabling
maximum performance to reproduce the most demanding home theater and music with
authority, accuracy and low distortion. The SC-IF/IC is easy to install whether it's for new
construction or retrofit – four adjustable brackets are included that can be attached anywhere
on the cabinet surface. The SC-1250, a rack-mountable amplifier that powers the SC Series,
features 3000 watts dynamic / 1250 watts RMS power and can easily drive twin SC-IF/IC
subs using standard speaker wire.
The SC-IF/IC can be installed in a variety of locations and positions for a given
installation. The SC-IF/IC can be used in-floor, in ceiling, or in other applications – all that is
required is a sturdy stud frame to mount to and a way to mount a decorative grille. The woofer
cabinet is 14” wide so ideally installs with 16” joist spacing. However, spacer boards can be
used to adapt the SC IF/IC to any application.
This document provides the detailed process for properly installing the SC-IF/IC. The
user’s manual for the SC-1250 subwoofer amplifier provides the details on connectivity
and proper configuration of the SC-IF/IC after installation. Note that two SC-IF/IC
subwoofers can be driven with a single SC-1250 amplifier. IT IS STRONGLY RECOMMENDED
THAT ONLY THE SC-1250 AMPLIFIER BE USED WITH THE SC-IF/IC.
AWord About Grilles
The SC-IF/IC comes with a permanently attached protective metal grille. This is intended to
protect the driver from debris falling into it in in-floor installation situations. No register or
decorative grille is provided – the installer must determine the location of the subwoofer and
what is to be used as a register or other decorative grille to hide the subwoofer enclosureafter
the installation is complete.

Installation — Step-By-Step
2
.www.velodyne.com SC-IF/IC User’s Manual
Step 1 -
Determine installation location. As stated above, the SC-IF/IC can be mounted virtually
anywhere. The only requirements are that the cabinet fit into the location, and that there be
proper venting for the audio to be passed into the listening environment.
Step 2 -
Mark installation location. It is useful to place the subwoofer cabinet in its proposed position
and mark the locations of the four brackets that will be used to affix the subwoofer to the
framing. Note that the brackets can be mounted ANYWHERE on the subwoofer cabinet, as
long as the brackets do not interfere with the woofer’s operation. Always use all four brackets
in the installation. It is recommended that the cabinet be positioned flush with the face of the
joists for ease of positioning and installation, but this is not required. Make sure the speaker
terminals are facing the direction you intend to run the speaker wire.
Figure1: Mark bracket locations with a pencil.
Note: The brackets can be attached anywhere on the SC-IF/IC cabinet.

3
.www.velodyne.com SC-IF/IC User’s Manual
Step 3 -
Determine and mark grille location. From the centerline of the subwoofer driver, mark off the
dimensions of the grille opening to accommodate the decorative grille chosen for the end user
installation.
Step 4 -
Prepare the installation location. Make whatever modifications are required to enable the
subwoofer to fit in the installation location. Note that the SC-IF/IC is designed for joists on 16”
centers. Install spacer studs as required to accommodate this dimension.
Step 5 -
Attach the mounting brackets. Attach the mounting brackets to the cabinet as indicated in
step 2.
Figure 2: Mount brackets on subwoofer cabinet.

4
.www.velodyne.com SC-IF/IC User’s Manual
Step 6 -
Attach the PSA-sided foam strips to the subwoofer cabinet. MAKE SURE STRIPS ARE USED
ANYWHERE THE CABINET WILL COME INTO CONTACT WITH THE STRUCTURE IN ANY WAY.
The SC-IF/IC is a powerful subwoofer and will likely buzz or rattle if not isolated from the
structure using the provided foam strips.
Figure3: Affix foam strips.

Step 7 -
Install. Place the SC-IF/IC as determined in step two and attach the brackets loosely.
CAUTION: The SC-IF/IC is heavy. Either use a partner to suspend the subwoofer while you
are attaching it or use a mechanical device to hold it in place during installation.
Figure4: SC-IF (In-Floor) positioned into floor location.
5
.www.velodyne.com SC-IF/IC User’s Manual

6
.www.velodyne.com SC-IF/IC User’s Manual
Step 8 -
Adjust position and tighten. Position the subwoofer into its final location and tighten
the brackets.
Figure5: Tighten the brackets.

7
.www.velodyne.com SC-IF/IC User’s Manual
Step 9 -
Secure wiring. Attach the speaker wire to the speaker terminals. A 16 AWG or heavier wire
is recommended. Be sure to secure the speaker wire so it does not rattle or buzz against the
cabinet during use. BE SURE NOT TO CROSS THE SPEAKER WIRES AS THIS CAN DAMAGE
THE AMPLIFIER.
Figure 6a, 6b, and 6c: Speaker wire connection.

8
.www.velodyne.com SC-IF/IC User’s Manual
Step 10 -
Complete installation. Install the decorative grille and perform any other tasks needed to
complete the installation based on chosen woofer positioning. It is recommended to use
caulking to secure the decorative grille to prevent buzzing and rattling.
Figure 7: Finished installation with register
Step 11 -
Check for rattles and buzzes. Use aggressive bass material and check the subwoofer for buzzes
and rattles. These can come from inadequate use of the foam strips, or there may be
sympathetic vibration in the structure due to the powerful nature of the SC-IF/IC. In the latter
case, track down the rattle and secure it with caulking or other similar material.

9
.www.velodyne.com SC-IF/IC User’s Manual
FOR YOUR RECORDS. . .
Date Puchased_________________________________________________________________
Dealer_________________________________________________________________________
Serial #________________________________________________________________________
*NOTE: Please complete and return your warranty card within ten (10) days or
Register. . . ON LINE . . . It’s faster . . . and easier
www.velodyne.com
LIMITED WARRANTY
VELODYNE ACOUSTICS, Inc. (“VELODYNE”) warrants all electronics and powered subwoofers for a period of two
years and full range speakers for a period of five years. All VELODYNE products have a warranty from the date of
purchase against defects in materials and workmanship subject to the following conditions:
1. VELODYNE is not responsible for defects which result from the use of an amplifier or controller other than
the one originally supplied with the unit (subwoofer) or defects which result from modifications or repairs
made by any component of the system by anyone other than a VELODYNE factoryauthorized
service representative.
2. This warranty is void if any repairs or service covered by the terms of this warranty are made to any
component of the system by anyone other than a VELODYNE factory authorized service representative.
3. VELODYNE is not responsible for damage caused by accidents, abuse, misuse, natural or personal disaster
or unauthorized modification. The VELODYNE products are not intended for professional or commercial use
and VELODYNE is not responsible for damage resulting from such use.
4. The VELODYNE product warranty is limited to units that are purchased from authorized VELODYNE dealers
and finalized within authorized dealer locations.
5. This warranty is nontransferable under any condition.
TO OBTAIN SERVICE
Information regarding service may be obtained from the dealer from whom you purchased the unit, or by contacting
VELODYNE customer service. Warranty service must be performed by a VELODYNE factory authorized service
representative within the warranty period set forth above. If VELODYNE determines the unit is defective, VELODYNE
will, at VELODYNE’soption, repair or replace the product at no charge if the product is forwarded prepaid to a factory
authorized service representative. Products forwarded to the factory authorized service representative should be
shipped securely and properly packaged, insured and freight prepaid.

10
.www.velodyne.com SC-IF/IC User’s Manual
Other Velodyne Products
DD Series
DD-10
DD-12
DD-15
DD-18
Digital Drive 1812
Signature Edition
DLS™-R Series
DLS-3500R
DLS-3750R
DLS-4000R
DLS-5000R
DPS™ Series
DPS-10
DPS-12
MiniVee™
SMS™-1
110V
SPL™-R Series
SPL-800R
SPL-1000R
SPL-1200R
SPL-1500R
SubContrator™
Series
SC-1250
SC-8
SC-10
SC-12
SC-15
SC-IW
SC-IF/SC-IC
VRP Series
VRP-1000
VRP-1200
VX™ Series
VX-10
DD Series
DD-10
DD-12
DD-15
DD-18
Digital Drive 1812
Signature Edition
CHT-R Series
CHT-8R
CHT-10R
CHT-12R
CHT-15R
230V
SMS™ -1
SPL-800i
SPL™-R Series
SPL-800R
SPL-1000R
SPL-1200R
SPL-1500R
SubContrator™
Series
SC-1250
SC-8
SC-10
SC-12
SC-15
SC-IW
SC-IF/SC-IC
®®

11
.www.velodyne.com SC-IF/IC User’s Manual
Velodyne Acoustics, Inc.
345 Digital Drive
Morgan Hill, CA 95037
408.465.2800 voice
408.779.9227 fax
408.779.9208 service fax
www.velodyne.com
Service E-mail: ser[email protected]
Product E-mail: [email protected]
Technical E-mail: [email protected]
63-SCIFC Rev A OCT06