Vertere DG-1 Dynamic Groove User manual
DG-1 dynamic groove
Quick Installation Guide
Vertere DG-1 QSG1 Rev D.indd 1 17/10/2019 09:10
Quick Installation Guide
DG-1 dynamic groove
1. Start Here
Congratulations on your new record player. The DG-1
dynamic groove will provide you with many years of
impeccable performance and help bring you as close to
your music as possible.
Installing and setting up your DG-1 is described in the
following pages predominantly pictorially, however before
the pictures begin, we must ask you to read some statutory
Important Safety Instructions followed by some critical
installation “Do’s and Dont’s”.
Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Do not submerge the equipment in water or liquids.
7. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
EQTPMǻIVWXLEXTVSHYGILIEX
8. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The
wide blade or the third prong are provided for your
WEJIX].JXLITVSZMHIHTPYKHSIWRSXǻXMRXS]SYVSYXPIX
consult an electrician for replacement of the obsolete
outlet.
9. Protect the power cable from being walked on or
pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
10. Do not unplug the unit by pulling on the cable, use the
plug.
4RP]YWIEXXEGLQIRXWEGGIWWSVMIWWTIGMǻIHF]XLI
manufacturer.
12. Unplug this apparatus during lightning storms or when
unused for long periods of time.
7IJIVEPPWIVZMGMRKXSUYEPMǻIHWIVZMGITIVWSRRIP
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cable or
plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally,
or has been dropped.
14. The appliance coupler, or the AC Mains plug, is the
AC mains disconnect device and shall remain
readily accessible after installation.
15. Adhere to all applicable, local regulations.
16. Consult a professional engineer when any doubt or
questions arise regarding a physical equipment
installation.
2. Do’s & Don’ts
Please read the following notes carefully, they cover
critically important aspects of your DG-1 installation.
•Always lift or lower the platter vertically when
removing or replacing it. Do not allow it to tilt.
ƽ &P[E]WIRWYVIXLI8SRIEVQ8VERWMXGVI[MWǻXXIH
[LIRMRWXEPPMRKEGEVXVMHKI
•Always ensure the Tonearm Transit Screw is
VIQSZIHFIJSVIYWMRKXLIVIGSVHTPE]IV
ƽ 3IZIVVIQSZIXLI2EMR'IEVMRKTMRHPI
ƽ 3IZIVVIQSZIXLI8SRIEVQJVSQXLI7IGSVH5PE]IV
[LIRǻXXMRKEGEVXVMHKI
ƽ 3IZIVVIQSZIXLI8SRIEVQJVSQXLI7IGSVH5PE]IV
[LIREHNYWXMRKXLIZIVXMGEPXVEGOMRKERKPI:8&
Vertere Limited,
5 Oliver Business Park,
Oliver Road,
London NW10 7JB, UK
8
E: info@vertereacoustics.com
W: vertereacoustics.com
Quick Installation Guide
DG-1 dynamic groove
3. Unpacking 1
7IQSZIXLIPMH[MXLMXWTVSXIGXMZIGEVHERHTPEGIXSSRI
WMHI
7IQSZIXLIGPIERMRKGPSXLERHTPEGIXSSRIWMHI
1MJXSYXXLIXSTXVE]7IQSZIERHGLIGOMXWGSRXIRXW
3.1
3.3
3.2
3.4
2EMRWTS[IVWYTTP][MXLEPXIVREXMZIQEMRWWSGOIX
EHETXSVW
2. Tonearm Counterweight
5LSRSMRXIVGSRRIGXGEFPI
4. Drive Belt
5LSRS,VSYRH;MVI
&PPIR0I]QQ
7. Spirit Level
&HHMXMSREP(SYRXIV[IMKLX3YXW
1MH-MRKI2SYRXMRK'EVWERH+M\MRKGVI[W
1
2
3
4
5
6
7
8
9
Vertere DG-1 QSG1 Rev D.indd 3 17/10/2019 09:10
Quick Installation Guide
DG-1 dynamic groove
4. Unpacking 2
7IQSZIXLIJSYVGSVRIVJSEQTEGOMRKTMIGIW
4.1
4.2
7IQSZIXLIGLEWWMWJVSQXLIGEVXSRERHVIWXMXSRMXW
PIJXWMHIXSKEMREGGIWWXSXLIYRHIVWMHI9RWGVI[ERH
VIQSZIXLIYRHIVWMHIXVERWMXWGVI[.JRIGIWWEV]YWIE
coin to assist loosening the transit screw.
1SSWIRXLIXVERWMXWGVI[SRP]YRXMPMXHMWIRKEKIWERH
MWJVIIXSFIVIQSZIH)SRSXTYWLXLIXVERWMXWGVI[
EWWIQFP]MRXSXLIGLEWWMW
8LIWEJIX][EWLIVTVIZIRXWXLIXVERWMXWGVI[EWWIQFP]
MREHZIVXIRXP]JEPPMRKMRWMHIXLIGLEWWMW
-SPHXLIXEF[LMPIVIQSZMRKSVVITPEGMRKXLIXVERWMX
WGVI[XSLIPTOIITMXWIGYVI
7IQSZIXLITVSXIGXMZITEHERHPMJXXLITPEXXIVJVSQXLI
GEVXSR9RTEGOMRKMWRS[GSQTPIXI 4.4
4.3
Vertere DG-1 QSG1 Rev D.indd 4 17/10/2019 09:10
Warning!
3*:*759118-*51&88*75.3)1*
4984+8-*'*&7.3,-49.3,
8LITPEXXIVFIEVMRKMWPSRKXIVQPYFVMGEXIHJSVRSMWIPIWW
ERHVIPMEFPISTIVEXMSRERHVIUYMVIWRSQEMRXIRERGI
&1;&= VIQSZIXLITPEXXIVF]PMJXMRKZIVXMGEPP]XSEZSMH
MREHZIVXIRXP][MXLHVE[MRKXLIFIEVMRKWTMRHPI
.JXLIFIEVMRKWTMRHPIMWMREHZIVXIRXP]VIQSZIH)4348
EXXIQTXXSVITPEGIMX8LIWTMRHPIVITPEGIQIRXTVSGIHYVI
VIUYMVIWWTIGMEPMWXXSSPWERHQEXIVMEPW
Quick Installation Guide
DG-1 dynamic groove
5. Assembly
5.2 +IIHXLIHVMZIFIPXEVSYRHXLITIVMTLIV]SJXLITPEXXIV
ERHLSSOMXSZIVXLIHVMZITYPPI]
(LIGOXLEXXLIHVMZIFIPXMWPSGEXIHGSVVIGXP]MRXLITYPP]
ERHTPEXXIVKVSSZIW
1S[IVXLITPEXXIVKIRXP]SRXSXLIFIEVMRKWTMRHPI0IIT
XLITPEXXIVLSVM^SRXEPEWMXMWPS[IVIH
5.1
5.3
5.4
Raise Lower
9WIXLIXLVIIEHNYWXEFPIJIIXXSPIZIPXLIVIGSVHTPE]IV
(LIGOPIZIPPMRKYWMRKXLIWTMVMXPIZIPTPEGIHSRXLIGIRXVI
HMWGSJXLITPEXXIV
90°
Vertere DG-1 QSG1 Rev D.indd 5 17/10/2019 09:10
Quick Installation Guide
6. Tonearm Set Up 1
9RWGVI[XLItonearm transit screwERHTPEGIMXMRXLI
TEVOIHTSWMXMSR
6.1
6.2
6.3
6.4
&XVERWMXWGVI[MWǻXXIHXSXLIXSRIEVQ
8[SGEVXVMHKIEPMKRQIRXTSMRXWEVITVMRXIHSRXLITPEXXIV
mat.
(LIGOXLIGEVXVMHKIE^MQYXL
;LIRXLIWX]PYWMWTSWMXMSRIHSRIEGLEPMKRQIRXTSMRX
XLIIRHSJXLILIEHWLIPPERHXLIGEVXVMHKIWLSYPHEPMKR
[MXLXLIVEHMEPTPEXXIVPMRI2SZIXLIGEVXVMHKIXSEHNYWX
DG-1 dynamic groove
6.5
90°
Vertere DG-1 QSG1 Rev D.indd 6 17/10/2019 09:10
Quick Installation Guide
7. Tonearm Set Up 2
DG-1 dynamic groove
+MRIEHNYWXXLIXVEGOMRKJSVGIF]QSZMRKXLIFEPERGI
[IMKLXFEGO[EVHWXSVIHYGIXVEGOMRKJSVGIJSV[EVHWXS
increase.
7.1
7.2
7.3
7.5
7.4
Loosen the securing screw to move the counterweight:
FEGO[EVHWXSVIHYGIXVEGOMRKJSVGIJSV[EVHWXSMRGVIEWI
7IXMKLXIRXLIWIGYVMRKWGVI[[LIRǻRMWLIH
9WIEKEYKIJSVQSVIEGGYVEXIXVEGOMRKJSVGIWIXXMRK
IXXLIERXMWOEXI
&HNYWXXLI:IVXMGEP8VEGOMRK&RKPI:8&WSXLEXXLI
GEVXVMHKIFSH]MWTEVEPPIPXSXLIVIGSVHWYVJEGI
Increase
:8&
7IHYGI Tighten
Loosen
Less
More
Vertere DG-1 QSG1 Rev D.indd 7 17/10/2019 09:10
Quick Installation Guide
8. Fit The Lid
.HIRXMJ]XLIX[SPMHLMRKIFEVQSYRXMRKLSPIWSRIIEGL
WMHISJXLIVIGSVHTPE]IVGVI[ELMRKIQSYRXMRKFEVMRXS
each hole. Just one is shown in the image.
*RWYVIXLEXXLILMRKIQSYRXMRKFEVWEVISVMIRXIH[MXL
XLIMVǼEXWIGXMSRWJEGMRKHS[R[EVHW7EMWIXLILMRKI
QSYRXMRKFEVWXSXLIZIVXMGEPTSWMXMSR
5SWMXMSRXLIPMHMRTPEGIERHMRMXMEPP]WIGYVIMX[MXLSRI
HSQILIEH&PPIRWGVI[SRIEGLWMHI)SRSXJYPP]XMKLXIR
XLIWGVI[W.RWIVXXLIWIGSRHWGVI[IEGLWMHIXLIRJYPP]
XMKLXIREPPJSYVXSWIGYVIXLIPMH)SRSXSZIVXMKLXIRXLI
screws.
8.1
8.2
8.3
DG-1 Quick Installation Guide • Revision D - 10/19
&PPWTIGMǻGEXMSRWEVIPMEFPIXSGLERKI[MXLSYXTVMSVRSXMGI*4*
9. Control and Illumination
9.1
XERHF]ERHWTIIH
GSRXVSPFYXXSR
Green 337IH45.
Connect the power supply.
DG-1 will switch on in
XERHF]
5VIWWERHLSPHXLIFYXXSR
JSVWMRXERHF]
LSVXTVIWWXLIFYXXSRXS
select 33 rpm.
Green illumination.
1MKLXǼEWLIWSRGI
for continuous white
illumination.
5VIWWXLIFYXXSREKEMRXS
select 45 rpm.
7IHillumination.
1MKLXǼEWLIWX[MGIJSV
white illumination in
XERHF]SRP]
5VIWWERHLSPHXLIFYXXSR
JSVWXSWXSTERHVIXYVR
XSXERHF]
Control Illumination
Vertere DG-1 QSG1 Rev D.indd 8 17/10/2019 09:10
Table of contents
