Vicon Surveyor x971 User manual

X971

Surveyor Mini Dome System

Vicon Industries Inc. does not warrant that the functions contained in this equipment will meet your requirements

or that the operation will be entirely error free or perform precisely as described in the documentation. This

system has not been designed to be used in life-critical situations and must not be used for this purpose.

Product specifications subject to change without notice.

Vicon and its logo are registered trademarks of Vicon Industries Inc.

Vicon Part No. 8006-8971-03-00 Section 1 Rev 1098

VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788

TELEPHONE: 516-952-CCTV (2288) FACSIMILE: 516-951-CCTV (2288)

TOLL FREE: 800-645-9116 UK: 44/(0) 1489-566300 INFOFAX: 800-287-1207

Dear Valued Customer:

Thank you for selecting Vicon systems and products for your

video needs.

Since Vicon’s beginning in 1967, our only business has been the

design, engineering, and production of the highest quality video systems

and equipment for use in a wide variety of security, safety, control,

surveillance, and communication applications.

We stand behind the quality and dependability of every product

with an industry leading Beneficial Use warranty.

If you are not satisfied with a Vicon product or service, I would

like to know. Your complete satisfaction is the mission of every Vicon

employee.

Sincerely,

Kenneth M. Darby

President

FCC Notice

NOTE: Complies with Federal Communications Commission Rules & Regulations Part 15, Subpart B for a

Class A digital device.

WARNING

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in

strict accordance with the manufacturer’s instruction, may cause interference to radio and television

reception. It has been type tested and found to comply with the limits for a Class A computing device in

accordance with the specification in subpart B of part 15 of the FCC rules, which are designed to provide

reasonable protection against such interference in a commercial installation. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause interference to radio

and television reception, which can be determined by turning equipment off and on, the user is encouraged to

try and correct the interference by one or more of the following measures:

•Reorient the receiving antenna.

•Relocate the equipment with respect to the receiver.

•Relocate the equipment away from the receiver.

•Plug the equipment into a different electrical outlet so that the equipment and receiver

are on different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional

suggestions.

The user may find the following booklet prepared by the Federal Communications Commission helpful:

“Interference Handbook, Bulletin CIB-2”

This booklet is available from the U.S. Government Printing Office, Superintendent of Documents, Mailstop

SSOP, Washington, D.C. 20402-9328, ISBN 0-16-045542-1.

WARNING: Power must be removed from this unit before removing circuit modules or Ribbon Cables.

CAUTION: This unit contains circuit cards with integrated circuit devices that can be damaged by static

discharge. Take all necessary precautions to prevent static discharge.

Contents

INTRODUCTION...................................................................................................................1

Unpacking and Inspection.............................................................................................................................1

Inspection for Visible Damage......................................................................................................................1

Inspection for Concealed Damage ...............................................................................................................1

Housings .........................................................................................................................................................2

Drive Mechanism Assembly..........................................................................................................................2

Camera/Lens Module .....................................................................................................................................2

Lower Dome....................................................................................................................................................2

V7UFR Fire-Resistant Shield.........................................................................................................................2

DRIVE MECHANISM ASSEMBLY .......................................................................................3

Installing the Camera/ Lens Module .........................................................................................................3

Switch Settings and Adjustments..............................................................................................................3

Setting the Service Switch ............................................................................................................................4

HOUSING INSTALLATION ..................................................................................................7

INDOOR PENDANT ..................................................................................................................8

Installation Using a Vicon Mount...............................................................................................................8

Installation Using a 1.5-inch Pipe..............................................................................................................9

DROPPED CEILING ............................................................................................10

Installation into a Dropped Ceiling ..........................................................................................................10

X971 Rev 1098 Surveyor Mini Dome System Contents •i

SOLID CEILING ............................................................................................................ 12

Installation Into a Solid Ceiling ............................................................................................................... 12

OUTDOOR PENDANT ................................................................................................ 13

Installation Using a Vicon Mount ............................................................................................................ 13

Installation Using a 1.5-inch Pipe ........................................................................................................... 14

WIRING .............................................................................................................................. 15

Installing the Cables ............................................................................................................................... 17

FINAL ASSEMBLY ............................................................................................................ 19

Installing the Drive Mechanism............................................................................................................... 19

Installing the Domes ............................................................................................................................... 20

For Indoor Pendant Installations............................................................................................................. 20

For Dropped Ceiling Installations ........................................................................................................... 21

For Solid Ceiling Installations ................................................................................................................. 21

For Outdoor Pendant Installations.......................................................................................................... 21

DISASSEMBLING THE MINI DOME ................................................................................. 23

If It It Is Necessary to Remove the Trim Ring......................................................................................... 24

OPERATION ...................................................................................................................... 25

Initial Power-Up ...................................................................................................................................... 25

Verifying Proper Operation ......................................................................................................................... 26

Running the Diagnostic Test .................................................................................................................. 27

MAINTENANCE ................................................................................................................. 29

CARE AND CLEANING OF METALLIZED DOMES.................................................................................... 29

CARE AND CLEANING OF CLEAR ACRYLIC DOMES ............................................................................. 29

Fuse Replacement ....................................................................................................................................... 29

SHIPPING INSTRUCTIONS............................................................................................... 31

REFERENCE ..................................................................................................................... 33

ii •Contents X971 Rev 1098 Surveyor Mini Dome System

Coaxial Cable ................................................................................................................................................33

Twisted-Pair Cable .......................................................................................................................................34

1.5-inch Pipe Designation............................................................................................................................34

TECHNICAL INFORMATION .............................................................................................35