Vicon CE-SETUP User manual

Vicon part number 8009-8246-00-00 Rev 0112
Page 1
INSTALLATION AND OPERATION MANUAL
CE-SETUP
IP CAMERA SETUP AND POE TESTER
The CE-SETUP provides a simple way to setup and focus PoE-powered IP cameras and
is an ideal tool for installers working with both CCTV and IT PoE-based systems. The
CE-SETUP is compatible with IEEE.802.3af and IEE.802.3at standards up to 30 W
See Figures 1 – 3for complete installation details.
Important Safety Warning:
Read and keep these directions
Heed all warnings
Follow all instructions
Do not use this apparatus near water
Clean only with a dry cloth
Install in accordance with the
manufacturer’s instructions
This installation should be made by a
qualied service person and should conform
to all local codes
See further safety instructions on page 3

Vicon part number 8009-8246-00-00 Rev 0112
Page 2
CAT5
FIGURE 1 – CE-SETUP
INSTALLATION AND OPERATION MANUAL CE-SETUP
TECH SUPPORT: 800.34.VICON (800.348.4266)
FIGURE 2 – CE-SETUP SIDES
Left Panel Right Panel
Directions for the CE-SETUP IP camera Setup and PoE Tester
Refer to Figure 3
• Disconnect the network cable.
• Connect pigtail cable to the camera.
• Connect network cable to “Network” connector.
• After the caemra power is ON, the CE-SETUP will display the PoE voltage applied to the camera.
• Open your browser or viewing software to view the camera image for adjustment.
FIGURE 3 – CE-SETUP CONNECTIONS
CE-SETUP
PoE Camera
PoE Switch

Vicon part number 8009-8246-00-00 Rev 0112
Page 3
© 2011 Vicon Industries Inc. All Rights Reserved. Vicon and its logo are registered trademarks of Vicon Industries Inc.
89 ARKAY DRIVE | HAUPPAUGE, NY 11788 | USA
T: 631.952.2288 | F: 631.951.2288 | TOLL FREE: 800.645.9116
WEB: www.vicon-security.com
UK: [phone]
MECHANICAL INSTALLATION INSTRUCTIONS
• Read and keep these directions.
• Heed all warnings.
• Follow all instructions.
• Do not use this apparatus near water.
• Clean only with a dry cloth.
• To reduce the risk of fire or electrical shock, do not expose these
products to rain, moisture, dripping or splashing.
• No objects filled with liquids, such as vases, shall be placed on
the equipment.
• DO NOT install the unit in a place where the operating ambient
temperature exceeds 75ºC.
• Make sure that the external power supply output voltage is in the
recommended range.
• Do not install near any heat sources such as radiators, heat
registers, stoves or other apparatus (including DVRs) that
produce heat.
• Protect the power cord from being walked on or pinched,
particularly at the power source, convenience receptacles and
the point where they exit from the apparatus.
• Only use attachments/accessories specified by the manufacturer.
• Unplug this apparatus during lightning storms or when unused
for long periods of time.
• Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as when a power supply cord or plug is damaged, liquid
has been spilled, objects have fallen inside the apparatus, the
apparatus has been exposed to rain or moisture, do not operate
normally or has been dropped.
WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. This
apparatus shall not be exposed to dripping or
splashing and no objects filled with liquids, such as
vases shall be placed on the apparatus.