VIDA TECH F7021 User manual

vidatechelevator.com
F7021 – CANBus 7” LCD indicator with gong
Installation manual
• Supply must be between 16VDC to 30VDC.
• Must be installed in COP
• Brightness of the LCD is controlled by “ brightness ” potentiometer.
• Press “ ENTER ” to go the main menu of the LCD, then navigate with “ UP/DOWN ” switches. Refer to F7022
operation manual on our website.
Status LED Description
No communicationSteady
Slow Blink Systen error
Communication active with no errorFast Blink
• Status LED :
USB
Input for USB key
UP
ENTER
DOWN
Button to change the
configuration on board
Status Arrv
Up
Arrv
Dn
USB
USB light
Status LED
(Refer to the chart)
Brightness
Switch setting
(Refer to the chart)
S1
ON
OFF
24V
COM
CANH
CANL
SHLD
CANBus
Supply
FM FA NoArr FBLT Portrait COM1 COM2 COM3
www.vidatechelevator.com
End of line: CanBus
volume

• Switch setting :
SW
#
S1
#
1 FM
FA
NoArr
FBLT
Portrait
COM1
COM2
COM3
2
3
4
5
6
7
8
Text
Communication CAN Vidatech CAN JRT
Description
ON -> Blank the display in fire mode
ON -> Blank the display in fire alternate mode
ON -> Blank the arrow
ON -> Portrait mode (If existing within the config)
ON -> 100% backlight intensity
OFF -> 80% backlight intensity (Backlight life enhanced)
CAN GAL
• To activate Gong option, user must program floor adress in the menu.