ViewZ VZ-UNBS SERIES User manual

LED CCTV VIDEO WALL MONITOR
Please read this manual thoroughly before use, and keep it handy for future reference.
Installation & Handling Guide
VZ-UNBS SERIES

2User Manual Visit the ViewZ USA website at https://www.viewzusa.com
Installation Note - Handling
STEP 1
Cauon
STEP 2 STEP 3
When moving a monitor,
• Make sure it's more than one person carrying it.
• Make sure not to grab the front bezel in any case. It cause serious panel damage.
1. Open the box.
2. Use the handle to pull out the monitor. Do not grab or touch the front bezel.
3. At least 2 people are required to mount or move the monitor. When carrying the monitor,
make sure not to carry it in the slanted posion.

3User ManualVisit the ViewZ USA website at https://www.viewzusa.com
Installation Note - Caution
Power / Light Leak Check up
Make sure the monitor is not standing at angle.
Do not drop or hit the edge of the monitor.
Do not place any heavy material on the top of monitor.
Do not push the top of front panel by hand.
Before installaon, please connect power to the monitor and conrm the monitor is
working correctly.

4User Manual Visit the ViewZ USA website at https://www.viewzusa.com
Installation Note - Stacking
Avoid impact to the edge of monitor during installaon to avoid damage to the
monitor. When installing the mounng brackets on the back of the monitor, make sure
it sits on a so surface. The ViewZ narrow bezel monitor is very fragile and requires
special aenon.
Make sure to check the protecon pads as shown above before installing the monitors.
Prior to installaon, remove the protecon pads. Keep the removed protecon pads to
use them later as necessary.
Gap : Max 1.2mm
Gap : Max 1.2mm