Vigilate VIGSB User manual

Operation Manual
VIGSB Wireless Smart Bulb
Pairing and Connecting the Smart Bulb with the System.
1. Disconnect the power supply before installing the bulb.
2. When you turn on the power, the bulb will turn on with a white light and
then begin flashing rapidly while waiting for your pairing.
3. Open the App, tap "Add Accessory" on the main screen or under "System
Settings".
4. Select "Learn mode" to pair the device.
5. Make sure the bulb is flashing rapidly, you can also make the bulb flash
rapidly by turning On and Off the power 3 times.
6. Configure the networking of the bulb under the guideline animation.
7. Name it, press "Save", the pairing result would be confirmed in App and the
bulb will stop flashing.

Operations and Settings
Go to accessory list and tape "Smart Bulbs", you will have the bulb in the page.
Press the "edit" button when the bulb is ON, you can set parameters here.
You can also add the bulb to "Main Page" of the App for operating quickly.
Safety Warning
The device is recommended for indoor use and only can be used in a dry area.
Please contact seller for replacement if there is any damage caused by
transportation.
Please plug in the bulb in proper condition and make it stay away from children.
Please plug in the bulb fully while using for safety concern.
Please do not disassemble it while the power is on, otherwise there may cause
bulb damage or security risks.
8W(60W)
Effect
800LM@2700K
60*117mm
45g