VigSys VR20 User manual

Wireless Data Gateway
Model VR20
Quick Start Guide Version 08.04
For Technical Support, please go to www.vigsys.net
© 2008 VigSys Sdn. Bhd. All rights reserved.
NEXT PAGE >>
Power off the router.
1
Power on the router.
5
To access the web-based utility, type “http://192.168.0.1” in your web browser and press
“Enter”.
1
When prompted to login, type “admin” in both the User name and Password fields, and then
click on the “OK” button.
2
Insert the SIM card (from your mobile network operator) into the SIM card compartment
located on the bottom panel of the router.
2
Connect the RJ45 cable from the router’s LAN port to your computer.
3
Connect one end of the power adapter to the router’s PWR port and the other end to the
electrical wall outlet.
4
Hardware Installation
Configuration

Wireless Data Gateway
Model VR20
Quick Start Guide Version 08.04
For Technical Support, please go to www.vigsys.net
© 2008 VigSys Sdn. Bhd. All rights reserved.
In the Basic > HSDPA webpage, depending on your mobile network operator, you may need
to enter the following information:
- User Name
- Password
- APN Name
- PIN Code
3
Leave other settings as defaults unless specified by your mobile network operator (Note:
some settings are empty by default).
4
If you have flat rate Internet access and you want the router to automatically connect to the
Internet every time it is powered on, select “Enable” for “Auto Connect”.
5
Click on the “Submit” button to save the changes.
6
To change the Network Name (SSID) for your wireless network, go to the webpage Basic >
Wireless.
7
You are encouraged to turn on the security for your wireless network. To do that, please
refer to Wireless Settings section in the User Guide.
9
If you do change any settings on this webpage, click on the “Submit” button to save the
changes.
10
Reset the router by powering it off and then power it on again.
11
Congratulations - you have successfully configured your router!
12
The default SSID is “umbra180”. You may want to change the SSID if:
- You want to use your own preferred name.
- Another wireless network operating in your area has already been using the default SSID.
8