A bank of eight C-3000’s has a 96 tenant capacity. By using
a C-1000B, three groups of eight C-3000’s can be com-
bined, expanding tenant capacity up to 288.
P
Ph
ho
on
ne
e.
..
..
.7
71
15
5.
.3
38
86
6.
.8
88
86
61
1
h
ht
tt
tp
p:
:/
//
/w
ww
ww
w.
.v
vi
ik
ki
in
ng
ge
el
le
ec
ct
tr
ro
on
ni
ic
cs
s.
.c
co
om
m
Model AES-2000
I
In
ns
st
ta
al
ll
la
at
ti
io
on
n
Model C-1000B
Model C-3000
Step 1. Connect a pair of wires from the AES-2000’s C-3000 screw terminals to the C-1000B’s LINE OUT TO PHONES screw
terminals.
Step 2. To connect the first group of eight C-3000s: Connect the C-1000B’s LINE IN screw terminals to the Master 1 C-3000’s
ENTRY 1 screw terminals.
Step 3. To connect the second group of eight C-3000s: Connect the C-1000B’s DOOR BOX 1 terminals to Master 2 C-3000’s
ENTRY 1screw terminals.
Step 4. To connect the third group of eight C-3000s: Connect the C-1000B’s DOOR BOX 2 terminals to Master 3 C-3000’s
ENTRY 1 screw terminals.
Step 5. Set DIP switch 3 of the C-1000B to the OFF position.
Step 6. A telephone line can be connected to the AES-2000’s CO screw terminals for remote AES-2000 programming or calling
tenants that do not have phone service.
Note: Connect the group of eight C-3000s in a Master/Slave configuration as shown in the C-3000 Technical Practice.
The following steps are to be used in conjunction with the diagram on the following page (page 2).
P
Pr
ro
og
gr
ra
am
mm
mi
in
ng
g
For the AES-2000 and the C-3000 to work in harmony, program them to have identical phone entry Call Times and Ring Counts. Failure
to do so will result in unexpected disconnect. The AES-2000 Call Time and Ring Count fields are found in the Building Selection’s “Setup”
pull down menu, under “Parameters.” See the C-3000 Technical Practice, Programming section Bfor programming the Call Time and
Ring Count on the C-3000s.
When programming the AES-2000’s Apartment Selection screen, a “C” in entered before the tenant’s phone number to access the first
C-3000 group. The second and third C-3000 groups require a”C” and a “#1” or a “#2” before the tenant’s phone number.
For Example: C01 - C96 for group one, C#1,01 - C#1,96 for group two, C#2,01 - C#2,96 for group three.
Important: The comma shown in the dialing string is for a 2 second pause, which is required for the C-1000A to switch to group 2 or 3.