Viking DGSU1004BSS Assembly instructions

Cleaning Tips Ranges/Rangetops/Ovens
Sealed Burner Top/Burner Bowls
After cooking, always wipe down burner bowls and the sealed burner top with hot, soapy water and a soft cloth. If spots still occur, use
Soft Scrub cleanser (without bleach) with a blue Scotch-Brite pad. Careful, Scotch-Brite can cause scratches on the porcelain surface if
scrubbed too abrasively.
After cooking, always wipe down grates and burner caps with a damp sponge and
dry thoroughly. Normal cleaning can be done with hot, soapy water and/or Soft
Scrub cleanser (without bleach) with a blue Scotch-Brite pad. If stubborn spots still
occur, then use Easy- ff Fume Free Max ven Cleaner (see first bullet below).
Procedure for oven cleaner use: Take grates and burner caps off unit – move outside and
place on newspaper. Spray with Easy- ff, let cleaner sit on spotted areas for 1 – 2 hours.
Clean off with hot, soapy water.
When cleaning grates and burner caps, make sure to thoroughly dry them, especial-
ly underneath. If the bottom portion does not totally dry before setting them back
on the cooking surface, they may rust. You can also set the grates and burner caps
on top of the burner and turn the burner on high for ten to fifteen seconds for extra
drying. To prevent rusting and discoloration, do not submerge grates in water to
soak for any length of time or run them through the dishwasher. If rust does occur, Bar Keeper’s Friend and a blue Scotch-Brite pad will
remove it. To condition grates and burner caps, apply a light coating of mineral oil or vegetable oil. Allow oil to soak in 15 minutes
before returning grates or burner caps to cooking surface.
Burner Bases
The base should be wiped regularly with hot soapy water at the end of each cooling period. D N T use steel wool, abrasive cloths,
cleanser, or powders. To remove encrusted materials, soak the area with a hot towel to loosen the material, then use a wooden nylon
spatula. D N T use a metal knife, spatula, or any other metal tool to scrape the aluminum base.
Grates/Burner Caps
(sealed and open burners)
®
Brass Trim
Using a soft cloth, wash with warm, soapy water only. All brass parts are coated with an epoxy coating. Do not use brass cleaners or
any all-purpose cleaner.
Knobs
Remove from unit and clean with hot, soapy water and a soft cloth. Scrub gently; do
not soak. Use of abrasive cleaners or ammonia-based products could possibly remove
the graphics. The white knobs are tougher to clean – 409 Professional Strength works
well. Dry thoroughly before replacing.
Control Panel
nly use hot, soapy water and a soft cloth. Use of abrasive cleaners or ammonia-
based products on the control panel could possibly remove the graphics.
Stainless Steel Surfaces
For everyday use, start with hot, soapy water and a soft cloth. Wipe dry. Finish with
a damp micro-fiber cloth. Make sure to rub in the direction of the grain/brushed fin-
ish. If anything acidic lands on it (lemon, tomato sauce, etc.) clean up immediately
because it will stain.
For optimum appearance use a stainless steel cleaner to remove smudges and fingerprints
and follow up with a polish such as Thor (www.thorproducts.com) to make unit shine. Cleaner
and polish should not be used daily. nce every couple of weeks should be adequate.

ven Interior
All ovens should be cleaned frequently with hot, soapy water.
Non self-cleaning ovens
• ven door: For non self-cleaning ovens, use Easy- ff Fume Free Max ven Cleaner. Apply oven cleaner with a damp sponge.
• ven racks and rack supports: Clean with hot, soapy water or Soft Scrub cleanser. Remove before self-cleaning.
• ven interior surfaces: Use Easy- ff Fume Free Max ven Cleaner. Follow manufacturer’s directions. For self-cleaning ovens,
remove oven racks and rack supports and follow self-clean instructions in the Use and Care Manual.
• Never line the oven cavity with aluminum foil. It will melt on and permanently damage the surface.
Self-cleaning ovens
• ven interior surfaces: Remove oven racks and rack supports (VGSC Ranges only) and follow self-cleaning instructions in the Use and
Care Manual.
• The infrared broiler should never be cleaned. Any cleaner can damage the special mesh screen and/or the igniter.
This cleans most efficiently while still hot.
G ill g ate: May be cleaned immediately after cooking is complete and before turning off the
flame. Use a soft bristle brush to scrub the grill grate. Dip the brush frequently into a bowl of
water. Steam is created as the water contacts the hot grate. The steam assists the cleaning
process by softening the food particles. For thorough cleaning of the grill grate, use grill clean-
er according to manufacturer’s directions and then soak 15 to 20 minutes in a hot water and
mild detergent solution. After soaking, scrub with a blue Scotch-Brite pad. Do not use a steel
wool pad or abrasive cleaners, for risk of damaging the porcelain finish. Dry thoroughly.
Flavo -gene ato plates: Scrape off all burned on debris. Soak 15-20 minutes in a hot water
and mild detergent solution. After soaking, scrub with a blue Scotch-Brite pad. Flavor-gener-
ator plates are also dishwasher safe.
Constructed of machined steel with blanchard finish.
First time use: Scrub griddle with mixture of one quart warm water and 1⁄4cup white vinegar, using
blue Scotch-Brite pad. Dry thoroughly. Wash griddle with warm, soapy water. Rinse off and dry thor-
oughly. Season griddle by thinly coating the surface with approximately 1⁄2to 1 teaspoon unsalted
vegetable oil. Apply to entire griddle using a paper towel or clean cloth. Let oil sit on griddle for
about one hour and then wipe down with a clean cloth to soak up any residual oil. The griddle is now
ready to be used.
• It is not necessary to wash your griddle after every use. When light cooking is performed, simply
wipe down the surface with a clean cloth or paper towel. The oils in the food in which was
cooked on the surface will naturally season the griddle.
• After heavy cooking is done and the griddle is still warm, you can pour some room temperature
club soda directly on the griddle. Using a metal spatula, pull oils and excess food towards the
grease trough. Wipe entire surface with a paper towel. Follow up with the seasoning process.
• Keeping your griddle well seasoned will prevent your griddle from surface rust. If your griddle is
not used for a period of time, it must be re-seasoned. Every time your griddle is washed, it must
be re-seasoned.
•It is no mal fo the g iddle to da ken ove time, possibly unevenly.
• Non-stick cooking sprays are not recommended, considering their high water content they have a tendency to burn on.
• Corn oil is not recommended due to their high sugar level. It will caramelize and burn on the surface making it very difficult to
remove.
• After using the griddle, always remove the grease trough located in the front. Simply pull the trough towards you and lift out. The
trough or tray trap needs to be cleaned after each use. Wash the trough in hot soapy water. If grease is permitted to accumulate, a fire
hazzard could occur.
IMPORTANT: Never flood a hot griddle with cold water. This promotes griddle warping and can cause the griddle to crack if contin-
ued over a period of time.
For heavy duty cleaning, Viking offers a Griddle Cleaning Kit (GCK). This fast and easy commercial grade cleaning system will clean
your griddle in a matter of minutes. To order, contact your local Viking dealer or order on the Viking Web Site at vikingrange.com –
Accessories – Cooking Accessories – Gas and Dual Fuel Accessories.
Char-Grill
Griddle/Simmer Plate
Viking Range Corporation
111 Front Street • Greenwood, Mississippi 38930 • 662-455-1200
For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web Site at vikingrange.com
F1809F MS1010