Vimo KLD67 User manual

KLD67
Liquid detector
User guide
GENERAL DESCRIPTION
The KLD67 liquid detector is designed to detect water or other conductive liquids.
It’s possible to protect rooms where the risk of flooding could be
dangerous.Detection sensitivity is set ≤25KΩ, the presence of a resistence in this
range produce the activation of a opto-relay that can drive load down to 150mA
60Vdc. The detector can be either placed on the floor or in vertical when fixed at
selectable heights. The detector is alarmed (open relay) when water reaches the
contacts. The nominal power supply is 12Vdc but a10,5Vdc-28,5Vdc range or 24Vac
is accepted too. A positive signal on the test terminal can simulate an alarm.
CABLE CONNECTION
OPTIONAL FLOOR FIXING BRACKET
NOT INCLUDED, CODE: KLD65SQ
INSTALLATION
To install the detector remove the cover and fix with screws and plugs in the points
shown in the figure.
Red: +Vdc/Vac
White: -Vdc/Vac
Blue: test
Yellow: NC not in alarm
Green: NC not in alarm

TECHNICAL DATA
Dimensions (without cable and contacts) mm 120 x 37 x 27
Cable length m 2
Weight 250 gr
Protection IP67
Functional temperature -5°C to +50°C
Supply from 10.5Vdc to +28.5Vdc or 24Vac
Absorption stand-by 10mA +/- 10%
Absorption in alarm 7mA +/-10%
Sensitivity ≤25KΩ
Sensing contacts a.c. to eliminate electrolysis
1.5KHz +/- 10%
Output Opto relay NC 150mA 60Vdc
N.B: Do not use with flammable liquids.
Vimo Elettronica s.n.c di Cavalleri R. L. & C
Via dell’Artigianato 32/Q 20865 Usmate Velate (MB)
Tel: [phone], fax: [phone], e-mail: [email protected] www.vimo.it
C.F.: 05096770150 P.IVA: 00804240968 C.C.I.A.A. DI MB REA ME-1176225