Vimo KLD65 User manual
KLD65
Liquid detector
User guide
GENERAL DESCRIPTION
The KLD65 liquid detector is designed to detect water or other conductive
liquids. It’s possible to protect rooms where the risk of flooding could be
dangerous.Detection sensitivity is set ≤100KΩ, the presence of a resistence
in this range produce the activation of a relay that can drive load down to 1A
30Vdc or 0.3A 110Vdc or 0.5A 125Vac. The detector can be either placed on
the floor or in vertical when fixed at selectable heights. The detector is
alarmed when water reaches the contacts. The nominal power supply is
13.8Vdc but a max of 27.6Vdc is accepted too for 24Vdc systems. A positive
signal on the test terminal can simulate an alarm.
CABLE CONNECTION
INSTALLATION
To install the detector remove the cover and fix with screws and plugs in the
points shown in the figure.
TECHNICAL DATA
Dimensions (without cable and contacts) mm 120 x 37 x 27
Cable length m 2
Weight 260 gr
Protection IP65
Functional temperature +5°C to +50°C
Supply +10.5Vdc to +27.6Vdc
Absorption stand-by 9.5mA +/- 10%
Absorption in alarm 40mA +/-10%
Sensitivity ≤100KΩ
Sensing contacts a.c. to eliminate electrolysis
1.5KHz +/- 10%
N.B: Do not use with flammable liquids.
Vimo Elettronica s.n.c di Cavalleri R. L. & C
Via dell’Artigianato 32/Q 20040 Usmate Velate (MB)
C.F.: 05096770150 P.IVA: 00804240968 C.C.I.A.A. DI MB REA ME-1176225
Table of contents
Other Vimo Security Sensor manuals
