Vinotemp VT-21-TEDS2Z User manual

21- Bottle
Wine Cellar
MODEL: VT-21TEDS-2Z
INSTRUCTION MANUAL
Please read carefully and follow all safety rules
and operating instructions.

Table of Contents
Cabinet and Circuit Diagram
page 2
Technical Data
page 3
Important Safety Instructions
page 4
Installation Instructions
page 5
Electrical Connection
page 6
Operating Your Wine Cellar
page 7
Care and Maintenance
page 8
Troubleshooting Guide
page 9
Limited Warranty
page 10
1

Cabinet Diagram
1. Hinge 6.Shelf
2. Light 7.Foot
3. Temperalurc Controller 8.Door Frame
4Temperature Display 9.Glass
5.Fan Mask lO.Handlc

Technical Data
Model no.
VT-21TEDS-2Z
Capacity 21 Bottles
Voltage 110V AC
Current
2A (77°F/25°C))
Protection class
I
Frequency
60 HZ
Climate class SN;N
Input power
MOW (77°F/25°C))
Power Consumption
KW.h/24h
1.2 (59°F/15°C))
Temperature Control Range
Up Zone 44-66°F(7-18°C)
Down Zone 50-66°F( 10-18°C)
Net weight 46.3 Lbs ( 21 Kgs)
Gross weight
50.2 Lbs (22.8Kgs)
Unit size
13.4"x32.3"x20.3"
(WxHxD)
340x820x515mm
Packing size
15.0"x33.4"x21.7"
(WxHxD)
382x852x550mm
3

IMPORTANT SAFETY INSTRUCTIONS
* WARNING *
To reduce the risk of fire, electrical shock
or injury when using your appliance,
follow these basic precautions;
• Read all instructions before using the wine cellar.
• DANGER or WARNING: Risk of child entrapment.
• Junked or abandoned appliances arc dangerous...even if they "just sit in the
garage a few days."
• Before you throw away your old wine cellar; Take off the door, leave the
shelves in place so that children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean appliance parts with flammable fluids. The fumes can create a
fire hazard or explosion.
• Do not store or use gasoline or any other flammable vapors and liquids in the
vicinity of this or any other appliance. The fumes can create a fire hazard or
explosion.
-Save these instructions-
4

INSTALLATION INSTRUCTIONS
Before using your wine cellar
• Remove the exterior and interior packing
• Check to be sure the following parts are included:
♦ For VT-21TEDS-2Z, 6 Slide out shelves.
♦ 1 Instruction manual.
• Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLING YOUR WINE CELLAR
• Place your appliance on a floor that is strong enough to support the appliance
when it is fully loaded. To level your appliance, adjust the front legs at the
bottom of the appliance.
• Installing the handle:
The wine cooler comes with 1 stainless steel handle. To install, simply screw
it to the door with the supplied screws.
• Door
. Handle
5

• For proper installation, keep away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the coating and heat
sources may increase electrical consumption. Extreme cold or hot ambient
temperatures may also cause the appliances not to perform properly.
• Not designed for placement in garage or basement. Designed for use inside
the home.
ELECTRICAL CONNECTION
* WARNING *
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized products service center.
This unit should be properly grounded for your safety. The power cord of this unit
is equipped with a 3-pin plug which mates with 3-pin wall outlets to minimize the
possibility of electrical shock. Do not under any circumstances cut or remove the
ground wire from the power cord supplied.
Don’t use extension cords.
This unit requires a standard 110V-60HZ electrical outlet with 3-pin plug.
The cord should be secured behind the wine cellar and not exposed or dangling to
prevent accidental injury.
6

IMPORTANT SAFEGUARDS
Do not store food in a wine cellar, as interior temperature may not get cool enough
to prevent spoilage.
OPERATING YOUR WINE CELLAR
It is recommended that you install the wine cellar in a place where the ambient
temperature is between 50°F and 80°F. If the ambient temperature is above or
below recommended temperature, the performance of the unit may be affected. For
example, placing in extreme cold or hot conditions may cause interior temperature
to fluctuate. The range of 44-66°F and 50-66°F may not be reached. The
temperature may fluctuate depending on whether or not the interior light is on or
off or whether the bottles are located on the upper, middle or lower section.
How to use the buttons on the Display Panel:
You can set the temperature as your desire by pressing the button. There are two
buttons on the panel and to adjust the temperature by 1°F between
44-66°F and 50-66 °F. You can turn the interior light on or off by pressing the
“A ” button.
7

CARE AND MAINTENANCE
Cleaning your wine cellar
• Unplug the wine cellar and remove the bottles and shelves.
• Wash the inside with warm water and baking soda solution. The solution
should be about 2 tablespoons of baking soda to a quart of water.
• The outside of the wine cellar should be cleaned with mild detergent and warm
water.
MAINTENANCE OF YOUR WINE CELLAR
Moving your wine cellar
• Remove all the bottles and shelves.
• Securely tape down all loose items inside your wine cellar.
• Turn the leveling legs up to the base to hvoid damage.
• Tape the door shut.
• Be sure the wine cellar stays in the upright position during transportation.
8

PROBLEMS WITH YOUR WINE CELLAR
You can solve many common wine cellar problems easily, saving you the cost of a
possible service call. Try the suggestion below to see if you can solve the problem
before emailing Vinotemp at [email protected]
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE CAUSE
Wine cellar does not operate (D Not plugged in © Using wrong voltage
©The circuit breaker tripped © Blown fuse.
Wine cellar is not cold
enough
® Check the temperature control setting, external
environment may require a cooler setting.
©The door is open too often.
©The door is not closed completely.
©The door seal does not seal properly.
©The wine cellar does not have the correct clearance at
the back and two sides.
The light does not work Call the service center.
Vibrations
Check to see that the wine cellar is level.
The wine cellar seems to
make too much noise
©The wine cellar is not level.
©Check the fans inside the cabinet and at the back of the
unit
The door will not close
properly
©The wine cellar is not level.
©The doors were reversed and not properly installed.
©The seal is weak.
©The shelves are out of position.
Temperature LED does not
display
©Main control board does not work.
©Temperature controller problem.
©There is some problem with the plug(no power supply)
Temperature LED display
error
Temperature sensor is cut off.
Buttons are not functional Temperature controller panel is damaged.
9