Vintage view Vino Styx User manual

There are two pre-drilled mounting holes in each rack. Appropriate fasteners for your wall surface must be utilized in
both mounting holes for proper installation. Fasteners for drywall and wood surfaces are included with your rack. We
recommend the following fasteners for these surfaces:
Fasteners:
• Attaching to drywall, use the 2 included Toggle Bolts
• Wood wall surfaces can use 2 included Screws (#8 X 1 ¼”)
• Concrete, Brick or Stucco: 3/16” x 1 ¼” masonry screw or #8 x 1 ¼” screw with appropriate size expanding
concrete anchor
Vino Styx Installaon Instrucons
Wine Master Cellars, LLLP • 10645 E 47th Ave, Denver, CO 80239 • phone: [phone] • fax: [phone] • VintageView.com
Required tools: Phillips Head Screw Driver
Level
Pencil
Drill and 1/2 inch drill bit
Tape Measure
Included Parts: 1 Vino Styx 2 Toggle Bolts
2 Screws 2 Mounting Hole Caps
Figure B
1. Mark the mounting hole locations - Reference
Figure A below to ensure appropriate minimum clearances
around the Vino Styx and hold the rack against the
wall. Use a level to ensure the rack is horizontal and
mark the mounting hole locations on the wall with a
pencil (Figure B) before setting the Vino Styx aside.
113/16"
113/16"
31/2"
3/8"
13"
47/8"
Figure A
2. Drill the anchor holes - Drill a 1/2 inch (13.7mm)
hole for the Toggle Bolts centered on the marked hole
locations (Figure C).
Note: If attaching to a wood wall surface more than 1/2
inch thick or if a hole location is over a stud, do NOT drill
the hole for the Toggle Bolt. Instead, a Screw should
be used to fasten the strip into the wood/stud at that
mounting point.
Figure C

For product warranty information, please visit: VintageView.com/support/warranty
We’re here to help, call us at 866-650-1500 with any questions.
Figure D
Figure E
4. Finish up - Install the mounting hole caps in the 1/2
inch holes on the face of the rack by pressing into place
(Figure E) and you’re done!
3. Install the rack - Remove the expanding nuts from the
Toggle Bolts. Insert the bolts through the mounting holes
and, with the wings of the nut oriented to fold toward the
head of the bolt, thread an expanding nut back onto each
bolt until the tip of the bolt starts to protrude from the
end of the nut. Hold the strip so the Toggle Bolt aligns
with the 1/2 inch holes and gently push the expanding nut
through the wall (Figure D). Ensure that the wings of the
expanding nuts have fully expanded on the back side of the
wall and tighten the bolts, verifying that the rack remains
level.